Driving high resolution SAR ADCs EET Videos 2/4/2016 Post a comment The LTC®6363 is a low power, low noise, fully differential op amp with rail-to-rail outputs optimized to drive low power SAR ADCs. The LTC6363 draws only 1.9mA supply current in active operation and features a shutdown mode which reduces the current.
Wide optocouplers help meet IEC 60601-1 requirements EET Videos 12/27/2015 Post a comment Vincent Ching, applications engineer at Avago Technologies, discusses how Avago’s ACNT family of wide optocouplers can help designers meet the isolation, creepage, clearance and DTI requirements specified in IEC 60601-1, the most relevant standard.
Ultralow noise & Ultrahigh PSRR EET Videos 8/4/2015 Post a comment The LT®3042 is a high performance low dropout linear regulator featuring LTC’s ultralow noise and ultrahigh PSRR architecture for powering noise sensitive RF applications.
Infineon returns to Mobile World Congress EET Videos 3/11/2015 Post a comment After a four-year absence, Infineon returns to Mobile World Congress with a low-power barometric pressure sensor, embedded Secure Element (eSE) chip for securing mobile and communications networks, iBadge system, and more.
How to pocket-size a power brick EET Videos 3/11/2015 4 comments A laptop’s 65-watt adapter can be made 6 times smaller and lighter, while saving energy with more efficient switching, explains Infineon’s Andreas Urschitz at Mobile World Congress 2015.
DAC for Demanding Signal Generation EET Videos 12/16/2014 Post a comment The LTC2000 high-speed DAC has low noise and excellent spectral purity for demanding signal-generation applications. This video shows the LTC2000 and LTC6946 high-frequency synthesizer -- a clocking solution with excellent noise and spurious performance.
MOSFET Failure Protection EET Videos 12/16/2014 Post a comment How do you protect the load and ensure output continues to regulate if a DrMOS or MOSFET failure occurs? In this video, we show how the LTC3774 controller can be used in conjunction with Hot Swap and ideal diode circuits to meet this challenge.
As data rates begin to move beyond 25 Gbps channels, new problems arise. Getting to 50 Gbps channels might not be possible with the traditional NRZ (2-level) signaling. PAM4 lets data rates double with only a small increase in channel bandwidth by sending two bits per symbol. But, it brings new measurement and analysis problems. Signal integrity sage Ransom Stephens will explain how PAM4 differs from NRZ and what to expect in design, measurement, and signal analysis.
January 2016 Cartoon Caption ContestBob's punishment for missing his deadline was to be tied to his chair tantalizingly close to a disconnected cable, with one hand superglued to his desk and another to his chin, while the pages from his wall calendar were slowly torn away.122 comments