Breaking News
Blog

ESD: Protection in the Nanosecond World

The ESD spike
NO RATINGS
< Previous Page 2 / 2
View Comments: Newest First | Oldest First | Threaded View
x_acto
User Rank
Rookie
More than just hard failures
x_acto   3/13/2014 6:08:15 PM
NO RATINGS
Most PCB and System designers focus on trying to eliminate hard failures and often overlook user induced soft failures. 

Pulse simulator systems for product characterization and qualification techniques were never intended for use by the system design engineer as root-cause analysis and debug tools.

Instead a solution to this problem has adapted EMI/EMC 3D scanning systems in conjunction with injected pulse generator simulators in both "current reconstruction" and transient susceptibility scanning modes to attempt to identify which individual components and nodes actually "feel" the residual and induced transient pulses, how much, and to what effect.

A recent EDN article <http://edn.com/design/test-and-measurement/4427136/Embedded-scanning--The-next-step-in-ESD-detection> takes a look toward the future of ESD scanning/reconstruction technology, including Embedded ESD Scanning.

The author of the article, Jeff Dunnihoo of Pragma Design in Austin, Texas, specializes in interface design and ESD architecture analysis.

Jeff recently presented his EMI/EMC 3D scanning solution to the members and guests of the IEEE Boston Reliability Society and the North East Chapter of the ESD Association.

resistion
User Rank
CEO
RC
resistion   3/6/2014 10:44:32 PM
NO RATINGS
Generally understood the capacitor to charge or discharge to steady state value, over a time scale of RC. So it effectively slows down the ESD pulse while also damping it and drawing the current. Also recall, no voltage discontinuities allowed on a capacitor.

millikans drop
User Rank
Blogger
Re: Low value capacitor
millikans drop   3/6/2014 1:06:15 PM
NO RATINGS
The problem with using capacitors as ESD protection elements is that to have any clamping effectiveness against the ESD pulse, you need a relatively high cap value... >10nF.  Of course, this high of cap will kill the link on higher speed ports (diff pairs).   The other issue is that unless the capacitor is physically large (0805 or larger), the capacitor itself could be damaged by the ESD.  

Measurement.Blues
User Rank
CEO
Re: Low value capacitor
Measurement.Blues   3/5/2014 9:05:22 PM
NO RATINGS
Any capacitance will slow the edges of the signal. If you can tolerate that, you may be OK.

_hm
User Rank
CEO
Low value capacitor
_hm   3/5/2014 6:39:36 PM
NO RATINGS
If high speed differential has very low value capacitors to gnd, will it help prevent limited energy ESD damage?

 

Radio
NEXT UPCOMING BROADCAST
EE Times Senior Technical Editor Martin Rowe will interview EMC engineer Kenneth Wyatt.
Top Comments of the Week
Like Us on Facebook

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
EE Times on Twitter
EE Times Twitter Feed
Flash Poll