"I expect to see far end noise in microstrip lines, but there's not supposed to be any far end noise in stripline," Jeff Loyer lamented. Yet, he and his team saw a strong far end cross talk signature in their measured data from long uniform test lines. An example of the far end noise measured between pairs of stripline and microstrip traces is shown in Figure 1.
Figure 1. Measured far end for microstrip (in red) and stripline traces (in blue) for the same rise time and same coupling, and same length pairs of lines.
What could be causing this far end noise problem in stripline? Was it from the board fab, the materials, or the board design, he wondered?
As a signal integrity engineer with Intel's server division, one of Jeff's roles is to develop test methods to evaluate new designs, materials and board fab suppliers. A standard test structure he and his team use is a pair of long, uniform, coupled transmission lines from which they get loss, singe ended and differential impedance and line to line skew, for example. The differential pair structures are probed from their ends using microprobes.
In a recent batch of boards, many striplines showed this far end noise problem. An obvious possibility was non uniform materials distribution in the stack up. The stripline signal line had a layer of core below it and pre-preg above it. If the dielectric constants of these materials were radically different from each other, this could cause the far end noise. But there was so much noise. Was this an indication of a bad batch of core or pre-preg?
This is where the detective skills of a good engineer come in. With a four port measurement, whether measured in the time domain or the frequency domain, there are 72 different, unique S-parameter elements, spanning time domain, frequency, single ended, differential, as step response or as impulse response. With so much data, it's important to be selective and data mine the most important terms.
Very nice article on cross talk through vias Eric, signal return paths are frequently overlooked when analyzing PCB problems. However, I have mixed feelings about use of "social vias" in a purely engineering text. On one hand purist in me objects to term used. On the other hand the term made me read the article in the first place! ;-) Kris
David Patterson, known for his pioneering research that led to RAID, clusters and more, is part of a team at UC Berkeley that recently made its RISC-V processor architecture an open source hardware offering. We talk with Patterson and one of his colleagues behind the effort about the opportunities they see, what new kinds of designs they hope to enable and what it means for today’s commercial processor giants such as Intel, ARM and Imagination Technologies.