I wonder, instead of using the shade, wouldn't it have been better to simple put a light-absorbing filter over the photovoltaic cells? The shade would shift in angle, exposing more of one cell than the other, while a filter would keep them even -- replicating Florida in Arizona.
The entire point was to make them uneven so that the array would shift to put them back in an even state. Without the shade, both panels reached saturation at all times. The shade gives a mechanical means of increasing the disparity between the two.
I know that's what he meant, Caleb, but I was confused by this part:
The MBED reads voltage from two small photovoltaic cells placed at right angles to each other. It rotates until the voltages on the two panels match. However, Davis found that this did not work in the Arizona sun as well as it did on his Florida workbench. The sun was too bright, and the difference between the panels was too minimal at any angle.
That made me wonder, if the Arizona sun was too bright, then why not make it less bright with a filtering lens? Wouldn't an opaque shade cast a longer and longer shadow as it tilts, thereby throwing off the direction more and more? I'm not getting that part.
I get it. So the problem wasn't that the sun was brighter, but was more evenly distributed -- the distance from one side of the board wasn't any different from the other side. That makes sense. I'm still not sure how he keeps the increasing angle of the sun against the shade from increasingly throwing off the calibration, but I'll just accept the notion that he found a solution. Thanks!
We at school tried to do this almost same thing. But We were using a stepper motor and it was more of a simulation as we didn't have real solar panels.
But, reading about this makes me question... how about using the same current that the solar panel yields as a measure or as the level to judge if the panel is receiving the light at the expected levels. Mmmm just by thinking on it I guess it would be more difficult as some variations are added to the system like the fact that the sunlight varies in the course of the day and also varies with the seasons.
Thus, perhaps this is something to consider for using all that horse power in the MBED brain ... to make it able to get the weather info and from that define a range of sunlight intensity. Then wage that with some tables which model the expected intensity during the day and season and vuola! now you can spare some hardware and save some bucks! If it's mass produced then you'd be saving a lot of dollars man!
The way the correction has been applied to rotate the panels to get maximum sunlight thruout the day, a similar correction can be done to track the sun's north south movement during the year. This is especially required for the regions which are away from the equatorial regions.