Over the years I've seen several home-made and small-production computer numerical control (CNC) mills. Believe it or not, I still see them to this day being released with ancient interfaces, often requiring serial at the very best. Synthetos is hoping to update this and bring CNC into the hands of a whole new market, through its CNC controller. Not only is controller fully USB, but the company has worked hard to bring a very accessible programing workflow to the entire system. Basically it has a "gcode interpreter on a chip," which means that any system that can push gcode can run this device.
I apologize for the audio on this video interview. Although it's particularly hard to understand, I think you'll glean the important bits about the Synthetos CNC controller.
Of course, all of that ease of use isn't worth much if the controller doesn't do a good job. Well, from the looks of it, Synthetos's is doing just fine. You can see a simple demo where a pendulum is agitated then brought to an immediate standstill, all without the use of any sensors. Riley also points out that several OEMs are using their system in their production models.
In my fairly limited experience, it seems that up till a few years ago most "usb" mills and similar devices were actually serial with a usb converter in the box. That conversion step has always been a buggy pain in the butt.
newer systems are natively usb and you can just stream g-code to the port. While it may be technically slightly more difficult to make a device that is native USB, the old image of buggy USB just isn't accurate any more.
I've seen a few systems that didn't natively support USB. While they would claim usb connectivity it was actually a USB to serial converter in the box. They were a mess to set up and I ultimately ended up just finding a machine that had serial (can be a hunt now days).
The usb part is not their main selling point, but I feel it is a fairly good feature to remind people of.
@Caleb: Really appreciate your efforts in bringing these start-up stories up!! Who knows....may be these guys will make it to the top one day. Pretty cool stuffs they are making...going though their website I see they have made & released the stepper motor driver card for the Arduino board, which enabled them to develop the G-code interpreter firmware and next they integrated the controller and drives in a board to come-up with the controller card itself. May be I don't understand the real advantage of using USB interface for receiving G-code yet, except for gaining higher speed & connectivity to the modern world. I also see the feature on https://www.synthetos.com/project/tinyg/:
"Networkable via RS485 to support motion peripherals and for networking multiple boards for multi-axis systems and for really interesting projects (up to 1000 stepper axes)"
I have been somewhat mystified by how long serial ports have held on in several application areas. I recently proposed a design using USB only to have a manager refuse to even consider it based on a previous bad experience that he had with the interface. USB certainly is not a simple as a serial port, but just the fact that serials are just about completely left behind on PCs should be the writing on the wall.
Does this device do realtime control over that port?
Join our online Radio Show on Friday 11th July starting at 2:00pm Eastern, when EETimes editor of all things fun and interesting, Max Maxfield, and embedded systems expert, Jack Ganssle, will debate as to just what is, and is not, and embedded system.