Hi, Tom: As you said, multiply is a series of additions -- but not dependent on the magnitude of the multiplier, only the number of 1 bits after making both operands positive by complementing if negative.

It is a shift and add sequence starting with the low order bit of the multiplier if it is a 1 add the multiplicand to the double wide product high order and shift right 1 into low order. if multiplier bit is zero, just shift product right one.

Repeat until higher multiplier bits are zero or shifts equal to multipl;ier width. If the high bits are all 0s, then just shift for the remaining word width.

Division was trial subtraction by subtracting the divisore fron the dividend, if the result was positive shift 1 into the quotient high bit else shift 0. Remainder is left in the reg that held the high order dividend and the quotient in the low order.

If the signs of the dividend and divisor were different, complement at the end.

This is best I remember, maybe a few details missing. The shifts amounted to *2 and /2 and the add/subtract would wind up in the appropriate power of two positions.

I think the constant used in the compiler is 1/10 so they are multiplying by the reciprical of 10 to effectively divide by 10.

Sounds a bit like Goldschmidt division: converting the factor 1/10 into X/(2^n). Multiply by X, shift N bits, done. Taking the upper 16 bits of a 32-bit word is equal to a 16-bit shift.

I suspect 1/10 doesn't translate perfectly to binary so, just like 1/3 becomes 0.33... you get a hex factor of 0x1999... in your division.

To save this item to your list of favorite EE Times content so you can find it later in your Profile page, click the "Save It" button next to the item.

If you found this interesting or useful, please use the links to the services below to share it with other readers. You will need a free account with each service to share an item via that service.