Memory Test Tips #3: Improving flash memory testing with pulse generators

Source measurement units (SMUs) are the most frequently used instruments in parametric test systems because they can supply DC voltage or current to the device under test (DUT) and simultaneously measure the resultant voltage or current. For some device testing, however, particularly in the case of flash memory, voltage must be applied in a time-controlled manner—often on the order of just a few microseconds—to prevent the DUT from overheating or overstress. As enterprise SSDs represent an increasingly large portion of the flash memory market, accurate lifetime evaluation of components and modules becomes more important than ever. Given that SMUs are not designed to modulate output voltages at the nanosecond scale, a pulse generator is typically a better choice. Let’s take a closer look at ways to optimize flash memory test for the most reliable results.

Flash memory basics
The dominant form of solid-state, non-volatile memory technology is currently flash memory. It is used in a wide variety of devices and applications, ranging from the common USB “thumb drive” to smartphones, MP3 players, and digital cameras. Flash memory is part of a class of MOS devices that use floating gates. There are two types of flash cells: NOR and NAND. In NOR technology, the storage cells can be programmed and erased individually. Unfortunately, the storage densities for this type of flash memory are comparatively low. With NAND devices, it’s possible to write to the cells individually, but they must be erased in blocks. NAND-type memory has a much higher storage density and is by far the most dominant of the two types.

In addition to the floating gate, NAND flash memory cells usually have a control gate, drain, source, and bulk (see figure 1). Both during endurance testing and in actual use, a memory cell is repeatedly set (programmed) and reset (erased) by applying or removing charge from the floating gate. Charge can be applied or removed from the floating gate of any type of flash memory cell via Fowler-Nordheim (FN) current tunneling or via hot-carrier injection (HCI). In a normal CMOS transistor, both of these mechanisms cause device degradation and are usually to be avoided, but in the case of flash memory, they are essential to the function of the device. At the same time, FN tunneling and HCI are also the reason flash memory cells have a limited lifetime.



When charge is applied to or removed from the floating gate, the threshold voltage (VT) of the underlying transistor changes (see figure 2). This threshold voltage change is what allows the flash memory cell to be used as a memory storage device. Further, once the charge is injected into or removed from the floating gate, the floating gate remains in that state even after power is removed, which means flash memory is non-volatile.



To program or erase a flash memory cell, a set of pulses are applied. Pulses are used because applying a steady DC voltage would cause the cell to be over programmed or over erased, which typically damages the gate oxide so that the cell cannot be set to the opposite state. The stimulus voltage must be applied in a time-controlled manner, which is why a pulse generator is required.