PORTLAND, Ore.—LCD vendors worldwide are being pressured by smartphone and tablet makers to quickly integrate touch into the display itself, using in- or on-cell sensors, but slow development has prompted add-on touchscreen vendors to offer interim sensor-on-cover, touch-on-lens, and similar one-glass solutions, at least for 2012.
In 2011, over 566 million projected capacitive touchscreens were shipped for smartphones alone, according to NPD DisplaySearch (Santa Clara, Calif.), and for 2012 that number is likely to mushroom as tablets, laptops, and all-in-one PC makers adopt add-on touchscreens in lieu of integrated touch with in- and on-cell LCDs.
LCD manufacturers all have intensive efforts underway to integrate the touch function into their LCDs, but according to NPD DisplaySearch, their slow development efforts will delay the introduction of integrated touch LCD until 2013.
Adding touch sensors to LCDs is problematic since the switching operations necessary to drive the liquid crystal transistors create transients that wash-out the signal coming from integrated touch sensors. LCD vendors are currently experimenting with noise-reduction and -avoidance techniques, such as multiplexing the tasks so that driving-the-LCD and sensing-touch are performed on alternative cycles.
In the meantime, for 2012 NPD DisplaySearch predicts that smartphone, tablet, laptop and all-in-one PC vendors will increasingly turn to sensor-on-cover solutions which pattern the touch sensors using a single piece of glass, instead of the two glass plates typically required today. Sensor-on-cover also has its problems, with yields reported to be as low as 70 percent, but for 2012 at least they are available, with end-user products slated to start using them with the new year.
Today touchscreens are added on to LCDs, prompting the move to single glass solutions, whereas future LCDs will have touch built-in either with in- or on-cell sensors.
This will also help for the problem of looking at the display at an angle. When I try to tap the display while looking at it from an angle, I seem to miss the target. With one less layer of glass, it should get better.
Add-on touch screens have probability of liquid getting in the gap and spoil the touch function. I faced it and replacing the touch screen is an expensive as 40-50Euros. For smartphones, its about the 10% of the original cost. Hopefully, we find the integrated solution soon.
David Patterson, known for his pioneering research that led to RAID, clusters and more, is part of a team at UC Berkeley that recently made its RISC-V processor architecture an open source hardware offering. We talk with Patterson and one of his colleagues behind the effort about the opportunities they see, what new kinds of designs they hope to enable and what it means for today’s commercial processor giants such as Intel, ARM and Imagination Technologies.