BANGALORE, India—A decision on the long-pending proposal to set up a domestic wafer fab in India is likely to be made by the end of March, semiconductor industry executives said.
India has been debating building a wafer fab for years. A decision on whether to move forward with a plan to build a fab here had been promised by the end of 2012. But that deadline came and went with no decision made.
Still, semiconductor industry executives here said they are now far more confident that a decision on the plan by India's national government is imminent. Their optimism is based on some policies conducive to domestic electronics manufacturing being adopted last year, with still others in the works.
"Electronics manfufacturing is being looked at more progressively," a representative of the India Semiconductor Association (ISA) said here Tuesday (Jan. 22).
A study conducted by the ISA and market researcher Frost & Sullivan on this market projected a compound annual growth rate of nearly 10 percent for India's electronics, system design and manufacturing market from 2011 through 2015. The market is expected to grow to $94.2 billion in 2015 from $66.6 billion in 2011, according to the study.
"This is a fantastic growth rate and should show the way to product development and value-added manufacturing domestically, rather than relying on imports and low value-added screwdriver assembly," the ISA said.
Fears loom over the import bill for electronic products though, with 65 percent of India's demand currently being met by imports.
Another worry is the projected decline in high value-added manufacturing within the country. Of the total electronics market of $44.81 billion in 2012, high value-added domestic manufacturing was just $3.55 billion. The ISA is concerned that this decline in high value-manufacturing will cause a cumulative opportunity loss of a whopping $200 billion by 2015.
India’s semiconductor market revenue was an estimated $6.54 billion in 2012. The country's semiconductor design industry is expected to grow at a 17 percent CAGR, amounting to over $10 billion in 2012. Of this, VLSI design accounted for $1.33 billion, embedded software for $8.58 billion and board/hardware design for $672 million. Related stories:
In my opinion, they should target high margin analog markets, 0.18/0.13 um BCD and SiGe BiCMOS processes.
I think with Tower Jazz being a stakeholder that could be one possible direction.
65/32/28 does not make sense for india since the industrial/communication market is quite big and those require robust analog process technologies...
Yet another announcement!! We have seen these come and go about Semi fabs, I can only hope it is different in 2013! India should focus on compound semi, analog, MEMS and other higher margin ones... and forget digital / ultra high volume (read: cheap & commodity-type) Si products.
The effort by India is too little, too late for next generation tech nodes. And the number of fabs are decreasing any at advance technology nodes and the investments run in billions.
Indian infrastructure is falling apart, with frequent blackouts, unreliable water supply and bone-jarring roads. Good luck setting up a Fab in this mess.
PS: Try polling Indian Solar cell makers on their experience with manufacturing
No...I don't think so.
HSMC was Hindustan Manufacturing Semiconductor Co. a plan that was floated in 2007
The latest plan is a government sponsored call for proposals that has been running through 2012. A consortium including Tower Semi and IBM is known to be pitching to build a wafer fab. The decision was expected by end of 2012.
I do not understand why they need/want a semiconductor fab? Solar I would understand. But why a semiconductor manufacturing facility now in India when more in the industry change from manufacturing to fab-lite or fabless.