Background The proliferation of ultralow power wireless sensor nodes for measurement and control, combined with new energy harvesting technology, has made it possible to produce completely autonomous systems that are powered by local ambient energy instead of batteries. Powering a wireless sensor node from ambient or “free” energy is attractive because it can supplement or eliminate the need for batteries or wires. This is a clear benefit when battery replacement or servicing is inconvenient, costly or dangerous.
Many wireless sensor systems consume very low average power, making them prime candidates to be powered by energy harvesting techniques. Many sensor nodes are used to monitor physical quantities that change slowly. Measurements can therefore be taken and transmitted infrequently, resulting in a low duty cycle of operation and a correspondingly low average power requirement.
For example, if a sensor system requires 3.3V at 30mA (100mW) while awake, but is only active for 10ms out of every second, then the average power required is only 1mW, assuming the sensor system current is reduced to microamps during the inactive time between transmit bursts. If the same wireless sensor only samples and transmits once a minute instead of once a second, the average power plummets under 20µW. This difference is significant, because most forms of energy harvesting offer very little steady-state power; usually no more than a few milliwatts, and in some cases only microwatts. The less average power required by an application, the more likely it can be powered by harvested energy.
Energy harvesting sources The most common sources of energy available for harvesting are vibration (or motion), light and heat. The transducers for all of these energy sources have three characteristics in common:
1) Their electrical output is unregulated and doesn’t lend itself to being used directly for powering electronic circuits 2) They may not provide a continuous, uninterrupted source of power 3) They generally produce very little average output power, usually in the range of 10µW to 10mW.
These characteristics demand judicious power management if the source is going to be useful in powering wireless sensors or other electronics.
Global Thermoelectric manufactures TEGs that convert heat into electricity. Using a burner you can generate continuous DC electricity with no moving parts. Generators range in output size from 15 to 550 Watts.
Click on the link below to check out the collection of the Design Articles, Case Studies, Product How-To articles, Teardowns, etc... related to energy scavenging that have been published on Smart Energy Designline.
Click here: http://www.eetimes.com/design/smart-energy-design/4372778/Energy-harvesting---Design-archive
Check back frequently. The list will be updated as new articles arrive.
David Patterson, known for his pioneering research that led to RAID, clusters and more, is part of a team at UC Berkeley that recently made its RISC-V processor architecture an open source hardware offering. We talk with Patterson and one of his colleagues behind the effort about the opportunities they see, what new kinds of designs they hope to enable and what it means for today’s commercial processor giants such as Intel, ARM and Imagination Technologies.