Venice, Florida — Mentor Graphics Corporation has introduced the next generation of PADS® flow with the introduction of PADS2007. PADS runs on Microsoft Windows and is the lower cost PCB development solution in Mentor's products offerings to this market. This release offers layout designers and engineers the ability to implement RF and microwave circuitry using automated functionality, perform design for fabrication (DFF) checking early in the design process, and optimize performance with high-speed analysis/verification functionality, thus improving their productivity and design quality.
Additional enhancements in this release include:
High-speed routing improvements: controls for matched length nets and differential routing improvements.
Square and chamfered corners, DXF-in import, and via matrixing enhancements for RF design.
Blind/buried via drill table improvements: designs with partial vias (blind or buried) are automatically updated with the layer pairs and drill count of the partial vias in the design.
Alpha-numeric pin improvements: simplifies creation of large BGA-based parts.
ECO enhancements: includes comparison of design rules between the schematic and layout databases.
Design for fabrication (DFF) analysis: powerful fabrication checks, such as acid trap, starved thermals, solder mask slivers are checked in the CAD environment and database, allowing the designer to identify and correct manufacturing problems in PADS Layout, before Gerber generation.
Pin number visibility: the user has the ability to turn on/off the visibility of the component pin numbers, either numeric or alpha-numeric, improving designer productivity during routing.
SI analysis: integration of DxDesignerTM and the HyperLynx® LineSim® tool through a new interface allows fast transfer of a circuit for analysis and back annotation of termination resistor values.
Analog simulation: provides a board level simulation analysis and verification through a common schematic editor for both simulation and PCB design entry.
The company did not furnish specific pricing information.
January 2016 Cartoon Caption ContestBob's punishment for missing his deadline was to be tied to his chair tantalizingly close to a disconnected cable, with one hand superglued to his desk and another to his chin, while the pages from his wall calendar were slowly torn away.122 comments