Milpitas, Calif. Linear Technology Corp. has expanded its I2C and SMBus bus buffer and rise time accelerator family with the introduction of the LTC4308 and LTC4309 level shifting buffers. Both hot swappable 2-wire bus buffers prevent signal corruption during I/O card insertion into live backplanes and provide capacitive isolation per I2C and SMBus specifications.
The LTC4308 is optimized for level translation down to 1 V and introduces a negative offset voltage for buses with very low pull-up supplies, while the LTC4309 provides a low offset voltage, fault flag, enable disconnect, and accelerator disable. These features make the devices suitable for a variety of computing, networking and data storage systems that use multiple I/O cards with different supply and bus voltage levels.
The LTC4308 provides automatic level translation from low-voltage systems (down to 1 V) to higher voltage systems (2.3 V to 5.5 V) using only a single supply pin. The LTC4309 has a second supply pin, allowing separate use of input and output bus pull-up supplies. Rise time accelerators provide strong, slew-limited pull-up currents that force the voltage to rise during positive transitions, which results in reduced power consumption, improved logic low noise margins and the ability to design with higher bus capacitances beyond I2C limitations, said Linear Tech. In addition, a 30 ms stuck bus timeout detects if SDA or SCL lines are stuck low so that the bus can be cleared and devices can be reset in order to resume proper system operation.
Although very similar in design, the LTC4308 targets busses that require low-voltage level shifting while the general-purpose LTC4309 supports a variety of additional features. The LTC4308's -200 mV output to input offset voltage allows communication with low-voltage components on the input side, whereas the LTC4309's 60 mV output to input offset voltage supports cascading of multiple bus buffers for bus extension. In addition, the LTC4309 is equipped with a fault flag that indicates a stuck bus, an enable disconnect that enables/disables the circuitry that disconnects the bus under a fault condition and an accelerator disable that deactivates the rise time accelerators for less capacitively loaded buses. Both devices offer +/-6 kV HBM ESD protection.
The LTC4308 and LTC4309 provide a variety of ordering options. "C" and "I" versions offer different operating temperature ranges, from 0°C to 70°C and -40°C to 85°C, respectively. The industry-standard packages for the LTC4308 include an 8-lead 3 x 3-mm DFN and an 8-lead MSOP, while the LTC4309 is available in a 12-lead 4 x 3-mm DFN and a 16-lead SSOP. All parts are RoHS compliant.
Pricing: LTC4308 pricing starts at $2.15 each and LTC4309 pricing starts at $2.25 each, both in quantities of 1,000.
Product information: LTC4308 and LTC4309
Linear Technology Corp., 1-408-432-1900, www.linear.com