antedeluvian - I guess that depends on how you did the upgrade. If you got your soldering iron out to do it, then you may or may not be able to put it back. Often this would be users who don't care all that much about the cal doing this sort of thing. If I didn't care about the precise cal or warranty I'd just measure a few test points and remember if it is a little high or a little low at high frequency and go from there.
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.