Breaking News
Comments
Newest First | Oldest First | Threaded View
Page 1 / 4   >   >>
Peter_Mould
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
Peter_Mould   7/31/2012 4:15:06 AM
NO RATINGS
This is certainly quite a surprising data to me. Who knew that the old diesel engine could be comparable to hybrids in terms of fuel efficiency. A driver that is looking to save money on fuel costs in the long term will certainly take this into account. Still, the amount of emissions that a diesel engine emits is largely over a hybrid engine, so in a way, hybrids are still better. Peter - http://www.pmwltd.co.uk/

cdhmanning
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
cdhmanning   2/4/2011 12:32:47 AM
NO RATINGS
Except that most car usage takes the car away from the home during the day (while the sun is shining) and would want to recharge during the night (when PV doesn't work).

prepka@behlman.com
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
prepka@behlman.com   2/3/2011 8:45:42 PM
NO RATINGS
Get your facts straight first. Current new diesels are extremely low in emissions now 2011 are availabe from many manufacturers with low sulfur diesel or biodiesel it is much easier now to meet the emissions. most manufacturers have met the federal requiremnts years ahead of schedule in order to meet the stricter Cal. requirements. I agree it is rather stupid to require older vehicles to comply with standards that they were not designed to meet. Diesel hybrids would require much smaller diesel engines since acceleration could be from battery power and diesel power combined and then recharge when power is not needed. Box trucks could be powered from a small direct injection turbodiesel. California is a bit out of hand with their emissions laws. They seem to mandate things that are difficult to achieve but then the rest of the country does not have a legendary smog problem as they do.

Scott.Bonomi_#1
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
Scott.Bonomi_#1   2/3/2011 5:58:26 PM
NO RATINGS
i would think that you also need to include the mass of waste per mile in the calculation. A lightweight hybrid that is scrap metal after 100,000 miles or a solid diesel that is still working just fine at 300,000 miles are going to be different in the amout of total pollution generated per fucntional passenger mile. The total energy bill, of manufacture, operation and disposal should be considered when looking at efficiency of the car as a system.

markogts
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
markogts   1/7/2011 3:44:02 PM
NO RATINGS
@Majestek: "More fuel burned = more emissions", sorry but this is not true. Quality of fuel and combustion type are way more important factors. And care has to be taken when speaking generally of "emissions". One thing is C02 emission, which is heavily (but not exclusively) linked to the amount of fuel burned; one other thing are pollutant emissions, which are higher in diesel engines, no matter how you measure it. A typical gasoline car has no particulate emission whatsoever, and HC/CO/NOx are quickly removed with a catalitic converter, while diesel engines require expensive exhaust treatment, subjected to maintenance and failures, and still leak some particulate. Moreover, while CO2 emissions are size-dependent, this is not the case for pollutant emissions: a recent huge SUV may well have lower pollutant emissions of an older compact.

MajesTEK
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
MajesTEK   1/7/2011 3:04:18 PM
NO RATINGS
@ Steve Ravet. You can't look blindly on the data. It may appear that diesel has higher emissions. But consider this. As others I drive the TDI Jetta. I manage to make a tank last two weeks before fill-up commuting to work. I would use twice the amount of gas which would cost me twice as much and I would burn up twice as much fuel. See where I'm going? More fuel burned = more emissions. I see two problems with the way we "quantify" things. 1. MPG is ok but it needs to be more like MilesPerDollar/Gallon. 2. When comparing emissions MPG should be taken into consideration

selinz
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
selinz   12/22/2010 5:59:58 PM
NO RATINGS
@nando basile: Autonomy? You have poor information. HEV's don'T EVER need to be plugged in. You simply put gas in like any other car. With my commute, I travel about 500 miles/week in my civic hybrid. I put about 10.5 gallons on Monday's. I also occasionally drive from SF to Mesa, AZ to work on our rental. Almost 800 miles. I have to stop for a body break more than to get gas (one gas stop does the trick for my 12+ hour trek).

selinz
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
selinz   12/22/2010 5:39:46 PM
NO RATINGS
I have to disagree with the author on one fundamental point. The city driving advantage is due to recovering the energy during the stop, not from stopping the engine. Simply shutting off the engine at stop signs is likely to provide marginal benefit. If you calculate the energy used to accelerate, being able to recover that dwarfs other effects.

tb1
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
tb1   12/17/2010 5:28:57 PM
NO RATINGS
http://en.wikipedia.org/wiki/Diesel_locomotive#Diesel-electric

tb1
User Rank
Author
re: Diesels challenge hybrids for efficiency, low emissions
tb1   12/17/2010 5:24:47 PM
NO RATINGS
What has held diesels back, at least here in California, is not prejudice, but emissions. When diesels can meet California's strict emissions standards, then they will be sold in the state. Until then, they can't be sold here. No prejudice--just cold hard numbers. Their are a few cars that now meet this and more are coming. What about an HEV powered by a diesel engine?--roldan Great idea. Haven't they been doing that with trains for decades now?

Page 1 / 4   >   >>


Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Radio
LATEST ARCHIVED BROADCAST

What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.

Brought to you by:

Like Us on Facebook
Special Video Section
The LTC2380-24 is a versatile 24-bit SAR ADC that combines ...
In this short video we show an LED light demo to ...
02:46
Wireless Power enables applications where it is difficult ...
07:41
LEDs are being used in current luxury model automotive ...
With design sizes expected to increase by 5X through 2020, ...
01:48
Linear Technology’s LT8330 and LT8331, two Low Quiescent ...
The quality and reliability of Mill-Max's two-piece ...
LED lighting is an important feature in today’s and future ...
05:27
The LT8602 has two high voltage buck regulators with an ...
05:18
Silego Technology’s highly versatile Mixed-signal GreenPAK ...
The quality and reliability of Mill-Max's two-piece ...
01:34
Why the multicopter? It has every thing in it. 58 of ...
Security is important in all parts of the IoT chain, ...
Infineon explains their philosophy and why the multicopter ...
The LTC4282 Hot SwapTM controller allows a board to be ...
This video highlights the Zynq® UltraScale+™ MPSoC, and sho...
Homeowners may soon be able to store the energy generated ...
The LTC®6363 is a low power, low noise, fully differential ...
See the Virtex® UltraScale+™ FPGA with 32.75G backplane ...
Vincent Ching, applications engineer at Avago Technologies, ...