Breaking News
Comments
Newest First | Oldest First | Threaded View
bcarso
User Rank
Author
re: Loudspeakers: Objective evaluations - Part 6: Other measurements
bcarso   5/4/2011 3:38:34 PM
NO RATINGS
That was done some number of years ago in a Kenwood amplifier, in a line they called "Audio Purist". It created a need for a composite cable with sense leads, but AFAIK the cable folks never picked up on it --- I would conjecture because it used a lot of negative feedback, which had gotten a bad name among audiophiles by then. See also Bruno Putzeys' article "The F Word", in Vol. 1 of the new bookzine Linear Audio, for some of the history of anti-negative feedback sentiment.

Hoyt_Stearns
User Rank
Author
re: Loudspeakers: Objective evaluations - Part 6: Other measurements
Hoyt_Stearns   4/28/2011 7:48:08 PM
NO RATINGS
Thank you for your article. Perhaps I missed it, but I haven't seen power amplifiers that attach sense wires to the loud speaker terminals for their negative feedback rather than at the output terminals of the amplifier. Power supplies do this, so I'd expect audio amplifiers would too, thus negating much concern for the types of cables.

bcarso
User Rank
Author
re: Loudspeakers: Objective evaluations - Part 6: Other measurements
bcarso   4/28/2011 4:33:26 PM
NO RATINGS
Wonderful stuff. However, please note that this is not a collection of contributions from various authors. Dr. Toole wrote it, in its entirety.



Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Radio
NEXT UPCOMING BROADCAST

What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.
Like Us on Facebook
Special Video Section
The quality and reliability of Mill-Max's two-piece ...
01:34
The quality and reliability of Mill-Max's two-piece ...
LED lighting is an important feature in today’s and future ...
05:27
The LT8602 has two high voltage buck regulators with an ...
05:18
Silego Technology’s highly versatile Mixed-signal GreenPAK ...
The quality and reliability of Mill-Max's two-piece ...
01:34
Why the multicopter? It has every thing in it. 58 of ...
Security is important in all parts of the IoT chain, ...
Infineon explains their philosophy and why the multicopter ...
The LTC4282 Hot SwapTM controller allows a board to be ...
This video highlights the Zynq® UltraScale+™ MPSoC, and sho...
Homeowners may soon be able to store the energy generated ...
The LTC®6363 is a low power, low noise, fully differential ...
See the Virtex® UltraScale+™ FPGA with 32.75G backplane ...
Vincent Ching, applications engineer at Avago Technologies, ...
The LT®6375 is a unity-gain difference amplifier which ...
The LTC®4015 is a complete synchronous buck controller/ ...
10:35
The LTC®2983 measures a wide variety of temperature sensors ...
The LTC®3886 is a dual PolyPhase DC/DC synchronous ...
The LTC®2348-18 is an 18-bit, low noise 8-channel ...