Hi David - sounds horrible! Can't help but ask what bait did you use in the traps? We have a terrible mouse problem here in my house, and the little devils are smart enough to avoid even peanut butter if it's in a trap!
Not sure what the equipment was, I have a photo of it somewhere. It was a pretty fancy PA, was controlled by the exciter which told it which channel it was on and you could manually preset the Ls and Cs in the PA tuning circuits, and it would remember the settings. I had problems with the moving contacts on the Ls, got round that by using graphite from a pencil as a conductive lubricant.
@ Whatever, I sometimes have craft syndrome too,
@ but the 2nd last word is different...
There are other interpretations, but this is a family site, huh Brian?
OK, was thinking of similar to the Heathkit SB220 with the front panel CW/SSB selector which varied the plate voltage (found the schematic online). The 3-500Z grids were DC and RF grounded, + bias was applied to the filaments and was NOT switched other than T/R. Cannot recall if this was actually class C in CW mode due to plate voltage change.
Then noticed from an online photo the SB220 is 2KW and you mentioned 1KW, so hunted up the SB200 schematic and saw there was no CW/SSB select. So then I assumed you were using something else.
Whatever, I sometimes have craft syndrome too, but the 2nd last word is different...
"...in class C... Usually they worked in FSK... On Sundays, however, I’d set the radio to SSB voice mode..."
Sounds like the PA tube bias was selectable for class C or linear for SSB. Have to agree this is a great story.
As the guy in Monty Python's "And now for something completely different" would say "This post is getting silly...."
So how about this
Hickory, Dickory, Dock
The mouse he got a shock
The arc struck on
The mouse was gone
Hickory, Dickory, Dock
I didn't mention the cats - as another poster remarked, my story was long enough already....
When I was there they had introduced a cat flu virus and we saw a fair few sickly and dead cats as a result of this. However as usual some of them were immune and bred up the population again. They also tried shooting them - we had a couple of guys on Marion doing just that - but 2 guys to cover over 100 square Km just doesn't work. When was your friend there?
Ref the hens - nice story...
My grandmother had a very soft spot for her bantam hens which would walk around anywhere they wanted - including in the house.
When one nested in the back of a valve radio it was left there to hatch out its brood and nobody was allowed to turn the radio on for fear of overheating the eggs or starting a fire.
Since WW2 was on at the time, the family would get on horses and ride 5 miles to the neighbour every noon for the news.
When a friend of mine went to Marion, the major pastime was hunting cats. The cats, which had been release to control the mice, were instead killing off the burrowing petrels and needed to be controlled.
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.