I had HP as a client in the mid-90's (the real HP...). A hardware guy had all of his instruments tied down to the back shelf of his workbench - I wish I had a picture. Each corner had 1/2" all-thread, and side-to-side was 2" angle iron. This was in Santa Clara, building 52-upper.
His actual bench was messy, of course.
A former co-worker (a EE) once pointed out that, no matter the size of the work surface, you always have the last 6 inches for the actual thing you are making.
Great pictures - fond memories of previous lives.
At a previous company I had a meeting in my boss's office. To sit down on any of the 4 chairs in the room meant moving a stack of paper 12 inches deep. The stack I moved had a report on the top of it written by my brother. He had left the company 5 years before. On that basis the bottom of the stack was probably an invoice for the Big Bang!
Good comment. I fully agree. I think this might be one of the reasons why there are so few
hardware engineers around. I am one of those and I start to feel like I am getting on my own. From hardware it is easy to skip to software, so no more managers pissin' in your neck ;-) Fortunately I started my own small company 12 years ago, and I can assure you that this boosted up my productivity !! ;-)
A recent place of no-longer employment had a rule that all useful under-bench junk be moved to the warehouse when VIP visitors arrived. Then of course the warehouse organizers would move the junk somewhere else and fail to keep records of the new locations. ie, permanently lost.
The real funny thing was these VIP visitors had no technical clue whatsoever. Our chief chimpanzee had a habit of wiring test racks with 100 ohm twisted pair connected directly (no balun) to 50 ohm coaxial cable when the TP ran short. Of course the VIP visitors were not technically astute enough to realize this was not acceptable. Still, when dealing with dummies, who cares?
Another similar con was to order all employees to park their cars in the front parking lot to make the place look busy for the visitors. Usually the employees parked in the rear parking lot.
The company? Think "I Cannot Believe this Schist"
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.