I had HP as a client in the mid-90's (the real HP...). A hardware guy had all of his instruments tied down to the back shelf of his workbench - I wish I had a picture. Each corner had 1/2" all-thread, and side-to-side was 2" angle iron. This was in Santa Clara, building 52-upper.
His actual bench was messy, of course.
A former co-worker (a EE) once pointed out that, no matter the size of the work surface, you always have the last 6 inches for the actual thing you are making.
Great pictures - fond memories of previous lives.
At a previous company I had a meeting in my boss's office. To sit down on any of the 4 chairs in the room meant moving a stack of paper 12 inches deep. The stack I moved had a report on the top of it written by my brother. He had left the company 5 years before. On that basis the bottom of the stack was probably an invoice for the Big Bang!
Good comment. I fully agree. I think this might be one of the reasons why there are so few
hardware engineers around. I am one of those and I start to feel like I am getting on my own. From hardware it is easy to skip to software, so no more managers pissin' in your neck ;-) Fortunately I started my own small company 12 years ago, and I can assure you that this boosted up my productivity !! ;-)
A recent place of no-longer employment had a rule that all useful under-bench junk be moved to the warehouse when VIP visitors arrived. Then of course the warehouse organizers would move the junk somewhere else and fail to keep records of the new locations. ie, permanently lost.
The real funny thing was these VIP visitors had no technical clue whatsoever. Our chief chimpanzee had a habit of wiring test racks with 100 ohm twisted pair connected directly (no balun) to 50 ohm coaxial cable when the TP ran short. Of course the VIP visitors were not technically astute enough to realize this was not acceptable. Still, when dealing with dummies, who cares?
Another similar con was to order all employees to park their cars in the front parking lot to make the place look busy for the visitors. Usually the employees parked in the rear parking lot.
The company? Think "I Cannot Believe this Schist"
A long time ago we needed to have some metal
castings milled to avoid shorting PCB etch when the castings were assembled to the PCB. We found a provincial government supported (NOT USA) shop to do the work.
When I brought the castings and rework drawings to the shop I was surprised to find it incredibly clean. And only 3 staff - a receptionist, a head honcho, and the machinist that actually did all the work.
Clean = no work in progress. Our tax dollars at worst.
Blog That A-Ha Moment Larry Desjardin 11 comments Have you ever had an a-ha moment? Sure, you have. The Merriam-Webster dictionary defines it as "a moment of sudden realization, inspiration, insight, recognition, or ...