Design Con 2015
Breaking News
Comments
Newest First | Oldest First | Threaded View
Page 1 / 2   >   >>
HarveyB49
User Rank
Rookie
re: Fun with electrolytic capacitors
HarveyB49   1/13/2012 10:41:40 PM
NO RATINGS
Brings to mind the "Little Jiffy Fuse Tester" we built and left in the shop. Just a simple little box with a pilot lamp, heavy duty pushbutton and heafty power cord. The instructions on the cover stated: "Plug into an outlet, lamp should light. Press button and release. If light is now off, the fuse was good." The operative phrase, of course "fuse WAS good". Surprising how many EE students (and even professors!) only caught on AFTER they had "tested" the fuse! Good times indeed!

Paul.Pacini
User Rank
Rookie
re: Fun with electrolytic capacitors
Paul.Pacini   8/4/2011 7:37:26 PM
NO RATINGS
As a technician at Linear Power (remember those amps, back in the monster car-audio days?) there were occasions when the board-stuffers would load large, filter electrolytics backwards which would blow-up with quite a bang when power was applied. They would also occasionally leave out the zener diodes from the shunt-regulators allowing the full rail voltage of +/- 63VDC to be applied half-a-dozen op-amps. Those would give a good pop leaving little craters where the dice would explode. We’d also put small 10uF caps in the female end of an extension cord, place it under a desk, then plug in the male end around the corner giving the prep people quite a scare. Fun times.

GPBobby
User Rank
Rookie
re: Fun with electrolytic capacitors
GPBobby   7/24/2011 7:53:42 AM
NO RATINGS
My father once told me how, while working in commercial refrigeration in the '40s, he could take a motor starting capacitor and charge it from a 110 ac line (of course peak voltage charge random). The cap (with screw terminals) was then left in the employee's phone booth as a doodling object. He said it was always funny how the secretaries and office guys simply ignored it, but every tech and mechanic, while talking, just had to finger the two terminals simultaneously.

SouthernKiwi
User Rank
Rookie
re: Fun with electrolytic capacitors
SouthernKiwi   7/20/2011 5:23:46 PM
NO RATINGS
In a two way radio I was a tech with a sig gen on my bench that just happened to cover broadcast FM. One morning I found out what station a co-worker listened to and intermittently turned on the sig gen for random seconds with no modulation. He never did figure it out.

bcarso
User Rank
Rookie
re: Fun with electrolytic capacitors
bcarso   7/20/2011 4:32:26 PM
NO RATINGS
A certain engineer at Harman-Kardon many years ago, when the company was still in NY, would reverse the electrolytics in power amps under test while people were at lunch. It's remarkable that no one was hurt. It's also no surprise that this person went on to a string of jobs thereafter. When he finally left one some years ago, more-or-less against his will, a good many people quit early that day and went out to celebrate.

Ron_Sparky
User Rank
Rookie
re: Fun with electrolytic capacitors
Ron_Sparky   7/20/2011 4:27:52 PM
NO RATINGS
In going to college in the 70’s we all had dial type phones in each of our dorm rooms. One trick was to remove the “Green” wire from the terminal block on an un-suspecting neighbors phone. Then call them up and leave my phone off the hook. Disconnecting the green wire caused the phone to continue ringing when answered. Short of re-connecting the green wire or disconnecting the phone there was little you could do to stop the ringing. (Phones in those days did not have connectors and were hard wired.) I usually hung up after about 20 minutes or so. Of course the neighbors caught on after a couple of times and would fix their phone only to pull that prank on the next victim.

Don J
User Rank
Rookie
re: Fun with electrolytic capacitors
Don J   7/19/2011 3:07:04 PM
NO RATINGS
Speaking of flashbulbs, many years ago (early '80s) I bought some "Magicubes" which were 4 flash bulbs in a plastic case. The nice thing about Magicubes was that they didn't required a battery, but used a striker to strike the base which contained a fulminate which initiated the flash. I rigged up a paperclip to trip the striker and placed it in a coworkers desk drawer. When he opened the drawer a string pulled the paperclip and tripped the striker. It was quite a wakeup!! I still have the cube and some spare bulbs in the back of my desk drawer. Maybe one of these days...

Rangerdog
User Rank
Rookie
re: Fun with electrolytic capacitors
Rangerdog   7/18/2011 3:27:17 PM
NO RATINGS
A charged condensor from a car's distributor was a favorite for my eigth grade prinicpal. At recess he would walk around on the playground and yell "Here, catch" and toss it to you. We took it as fun and made him teach us how he didn't get shocked himself. This was in 1960. Today, I'm sure that he would be in a lot of trouble. But in my opinion he was a great "hands on" teacher.

SmokenMirrors
User Rank
Rookie
re: Fun with electrolytic capacitors
SmokenMirrors   7/18/2011 3:04:49 PM
NO RATINGS
We had just learned about inductors and reactance in my basic electronics class and after the lecture, one of students came up and asked what I thought would happen if he stuck a small 10uH inductor in the lab bench wall socket (the class also doubled as a lab). I told him to figure it out, you have 120vac at 60 hertz an that if it was me I would think twice before doing it; I believe the current would be quite high. By then I was off on the other side of the class talking with my instructor and the other students- and then a BLAM! I can here pieces of the poor inductor ricocheted off the ceiling and walls. Fortuntely it was the end of class and most students had left. My respect for instructors in general went up another notch. You just never know what kind of students you will be getting... I wonder what job he has now???

Finleythewombat
User Rank
Rookie
re: Fun with electrolytic capacitors
Finleythewombat   7/18/2011 12:34:28 PM
NO RATINGS
The flashbulb thing is pretty funny, but the ones involving capacitors across mains powerlines and high-voltage charged electrolytics are just unbelievably stupid, cruel and dangerous, even for college kids. There are all sorts of ways pranks like that can go badly - or fatally - wrong. It's no wonder we engineers have a reputation as socially inept nitwits.

Page 1 / 2   >   >>


Top Comments of the Week
Flash Poll
Like Us on Facebook

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
EE Life
Frankenstein's Fix, Teardowns, Sideshows, Design Contests, Reader Content & More
<b><a href=Betajet">

The Circle – The Future's Imperfect in the Present Tense
Betajet
5 comments
The Circle, a satirical, dystopian novel published in 2013 by San Francisco-based writer Dave Eggers, is about a large, very powerful technology company that combines aspects of Google, ...

Max Maxfield

Recommended Reads From the Engineer's Bookshelf
Max Maxfield
27 comments
I'm not sure if I read more than most folks or not, but I do I know that I spend quite a lot of time reading. I hate to be idle, so I always have a book or two somewhere about my person -- ...

Martin Rowe

Make This Engineering Museum a Reality
Martin Rowe
Post a comment
Vincent Valentine is a man on a mission. He wants to make the first house to ever have a telephone into a telephone museum. Without help, it may not happen.

Rich Quinnell

Making the Grade in Industrial Design
Rich Quinnell
16 comments
As every developer knows, there are the paper specifications for a product design, and then there are the real requirements. The paper specs are dry, bland, and rigidly numeric, making ...

Special Video Section
The LT8640 is a 42V, 5A synchronous step-down regulator ...
The LTC2000 high-speed DAC has low noise and excellent ...
How do you protect the load and ensure output continues to ...
General-purpose DACs have applications in instrumentation, ...
Linear Technology demonstrates its latest measurement ...
10:29
Demos from Maxim Integrated at Electronica 2014 show ...
Bosch CEO Stefan Finkbeiner shows off latest combo and ...
STMicroelectronics demoed this simple gesture control ...
Keysight shows you what signals lurk in real-time at 510MHz ...
TE Connectivity's clear-plastic, full-size model car shows ...
Why culture makes Linear Tech a winner.
Recently formed Architects of Modern Power consortium ...
Specially modified Corvette C7 Stingray responds to ex Indy ...
Avago’s ACPL-K30T is the first solid-state driver qualified ...
NXP launches its line of multi-gate, multifunction, ...
Doug Bailey, VP of marketing at Power Integrations, gives a ...
See how to ease software bring-up with DesignWare IP ...
DesignWare IP Prototyping Kits enable fast software ...
This video explores the LT3086, a new member of our LDO+ ...
In today’s modern electronic systems, the need for power ...