I've liked this article as it has answered the same question I had: Why the LED lamps are so costly and I understand, more than electronics, the manufacturers need to do something on the heat management and the casing part to bring down the cost.
Like many of my fellow readers, I am also surprised to see the claim of high lifetime with the electrolytic capacitors in it.
I've several years experience in drivers for LED lamps, and did investigate visible and non-visible flicker. Next link provides my input for Energystar guidelines on LEDlamps and light modulation.
Electrolytics are available which survive 12,000 hours at 105C. Unless you are cooking your LED's then you can get extremely long lifetimes and my own patented 900 lumen, 90+lumens/w 60W equivalent dimmable design exceeds 98% efficiency so almost no heat from the driver. And all that with 0.993 PF excellent coliur rendering and NO EMI!
Good idea - there are CFL fittings that work like this, the 2-pin lamp has the tube and the starter and the ballast is separate. There are also 4-pin types for electronic ballasts. So same idea should be good with LEDs - and reduce the ongoing cost a bit maybe.
Hi I am from India and developed LED lamp that works out from the regular incandecent bulb sockets.All led bulbs require Electronics to step down the voltage as they work on 3.3 to 4 volts only.As the current requirements are more heat will be developed and cannot be avoided.The led may last more but the electronics is bound to fail soon than claimed.
Those would be directly emmitting diodes then. These diodes shine onto phosphors to make white light. The phosphors continue to glow for brief period after the diode stops emmiting and might be able to mask the flicker. We ran into a problem with white LEDs on a system that was trying to blink at a 50% duty cycle only to have the phosphor glow distort it.
I guess Incandescents have a good bit of thermal inertia and don't dim much if at all in between half cycles.
TV's would also have a bit of persistence on the phosphor...and CFLs also usually have an electrolytic in them. Whereas LEDs would definitely be on-off devices.
Memo to self...when studying engineering textbooks, do not move head.... ;-)
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.