I think that there are still few challenges for 3D IC design:
- How can we test all IC before they are stacked together?
- Most of current 3D IC is limited to memory or sensor only, it takes time to develop complete strategy for stacking real ASIC together
- Wafer handling and KGD becomes nightmare for product engineer
- How can we handle thermal issues?
- 3M approaches may be good solution and we shall see how to apply this for production. However, I don't prefer liquid cooling solution, it is too complicated for implementation
- New 3D chip architecture related with TSV placement will solve the problem with lower cost
- Is new 3D IC EDA tools required or not?
- I prefer hybrid 3D IC design flow, it re-uses most of current ASIC flow with minor modification, it not only reduces the cost but also shortens the design cycle. For example, the multiple die physical verification time can be reduced by 10X or more through minor changes in current flow.
I agree... secondly one must realize that 3D IC design is also a packaging exercise so that needs to be addressed concurrently. Otherwise, there will be costly repititions and try outs of what is manufacturable.
@Colin Johnson: other entities involved in 3D IC standardization is GSA which has been meeting 4 to 6 times a year on this topic, and Si2 Consortium.
IBM's work in 3D IC by stacking is nothing new, definitely not a secret. At CANDE 2010 and also at GSA 3D Standards meeting earlier this year, there were presentations by IBM folks so I am not at all surprised. What surprises me is 3M taking on the challenge to develop a thermal interface material with high conductivity for gaps less than 1um.
My earlier posting on 3D-related article is here:
yes, the TSVs will take up about 15 - 20 % space on a die ( including the bond pads & keep-outs to isolate transistors from stress induced by the TSVs ) but this would be a wash since no large bond pads would be required for wire bonds any more. Because of the short I/O length ( low loss ) and high I/O density possible, TSVs will enable a lot of high - perf / low - power / compact designs.
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.