As an on-PCB DC/DC converter, I can see that as the designer, I am responsable for the best practice in the supporting circuitry and layout design to minimize the coruption of Ground. I would like to understand better (1) how to determine if one converter or another may be designed better or worse for this particular trait and (2), when using a switching Mains supply to provide my DC power, what steps can I take to minimize the ground noise between the outoput of the power-supply and my device's circuits?
As a slight improvement, it might have been informative to include the specific physical location of the input capacitor described in your article (between the Vin pin of the converter IC/switch transistor and the anode of the switching diode).
Great article, Jeff -thanks!
There is some system bug which is preventing the "enlarge" of Figures 5 and 6 from appearing properly. Here are the direct links for those figures:
http://www.eetimes.com/ContentEETimes/Documents/Schweber/C0893/C0893-Figure5.pdf AND http://www.eetimes.com/ContentEETimes/Documents/Schweber/C0893/C0893-Figure6.pdf
Great article, I would like to get a PDF copy of it, but the print link does not seem to work.
To add to comment of agk re: winding inductor with low parasitic C, another trick is to have the turns at the ends of the winding (near the connection terminals) spaced further apart compared to turns in the middle of the winding. This is an old trick used by ham-radio builders, and can result is a smaller inductor than would result from spacing all turns the same distance apart, but of course the parasitic C is a bit higher.
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.