I think this might be possible @resistion...Every second generation is much stronger than intermediate versions...0.35um was very strong but 0.25um was weak, then 0.18um was very strong, 90nm so, so, 65nm was probably higher runner than 45nm...etc
With the great success of 28nm technology, all the resource are pulled in for production ramp up, it is good choice to offer single process for 20nm generation. Moreover, it is required large amount of efforts for design service support, especially for LDE modeling. Therefore, it is not pure technology decision but also business consideration.
The solutions exist to continue the technology roadmap, but they bring increased layout restriction and cost. Here you see the increased layout restriction manifested in a single process offering and the increased cost manifested in widespread use of multi-pattering techniques at 14nm and below. This is exactly why 3D-IC is becoming a reality as it's high cost is now more in line with the higher cost of smaller nodes. I don't think you will see the roadmap stop as we all want increased functionality in new products. But what you might see is a slow down or even reversal in Moore's law as it has applied to the cost of consumer products. The iPad 10 may be as expensive as a small car, but you may buy it anyway.
The Other Tesla David Blaza5 comments I find myself going to Kickstarter and Indiegogo on a regular basis these days because they have become real innovation marketplaces. As far as I'm concerned, this is where a lot of cool ...