LEDs are far too expensive considering all the things that could go wrong over an expected multi-year life. How often do incandescents break due to accidents, problems with fixture etc???
Expect a very conservative ramp in these products - i.e., only new construction where builder puts them in and subsequent home owner pays the price without much consultation.
The savings of LEDs are very real. I recently bought several 4W GU10 100lumen/W SMD LEDs to replace 40W downlights. They cost just £6 per bulb including postage...
That means after just 833 hours they will have paid themselves back at £0.20 per kWh (yes, UK prices...). At 3 hours a day that's just over 9 months. So who cares if they last only a few years? They will have paid themselves back many times over by then.
@chanj: you are correct, the power electronics components will be the ones to die first, in particular the driver.
In the LED's, there may be an accelerated decay in the chromaticity / CCT of the white light depending on the ambient temperature and the hours of use. Without these mitigating factors, it is safe assume that LED's can last 10 to 15 years!
Incandescent bulbs have gotten a bad rap. OK, they're not especially efficient in making visible light. BUT there's is more to the problem set than producing lumens. In North America the vast majority of the population lives north of 30 degrees north latitude which means there is a significant seasonal change in hours of daylight. ALso, obviously there is a strong correlation between shorter days and lower temperatures - meaning that a residence requiring both heat and light simultaneously is to be expected. When I turned on the 100W incandescent on my nightstand this morning not only did I receive illumination but heat - as it was 9F outside any heat produced by the incandescent bulb was a welcome addition - and heat that my furnace then did not have to produce. While this little "space heater" may not be quite as efficient as my natural gas furnace in heating my house NOT A SINGLE JOULE WAS WASTED! Now the same can be said for the lesser amount of heat produced by any other electrically powered lamp - like LED. However, incandescent bulbs are cheap to make and are easily and safely recycled. OK so what happens on a warm July morning or evening? Well unless I'm getting up before 5am or VERY cloudy there will be ample natural light - and even at night, it's usually well past 8pm before I need to turn on interior lighting. Sure, the heat generated by my incandescent will indeed be wasted then, but only during this fairly limited span of the calendar. My back-of-the-envelope calculation shows that when you include the visible and infra-red light given off by an incandescent 100W bulb it's only at a ~15% disadvantage in total system efficiency compared to a similar amount of lumens produced by a MUCH more expensive LED bulb. BTW - I design LED lamps (commercial T-8s, etc) so I am no novice to solid state illumination.
About that Philips LED bulb, its quality issues, and issues over how
it won the US Govmt prize...
The poor quality of the bulb on testing and how competition rules were skirted - as referenced with competition rules, patents, lobbying
finance records, the prize committee's own lab test review document
and publicly less known designated lab test reports released on Freedom of Information requests.
All lighting has advantages.
No lighting technology can "replace" another.
LEDs are ideal in sheet or panel form,
Fluorescents in long tube form.
As with this warm fixed color temp incandescent copying Philips LED bulb,
they are compromised as politically pushed replacements for simple incandescent bulbs
- with particular difficulties to achieve omnidirectional and broad spectrum and, not least, bright 100W+ equivalent lighting in the small bulb format.
The Deception behind the Light Bulb Switchover
13 points, referenced
I have no problem at all with retaining the standard Edison base. For one thing, it means that using LED bulbs does not mandate buying all new light fixtures for the entire house. Hardly something to ignore.
For another, it means that when you change the LED bulb, which on average should be several years, the electronics are trivially easily changed along with the bulb. Without having to go through an INEVITABLY more complicated procedure, should the electronics, part of the lamp fixture itself, go bad.
Besides, it wouldn't be all that hard to have the LED part of the bulb be a separate piece from the Edison base which houses the electronics. Snap the LED glass part onto the Edison base. Assuming the electronics are good enought to last way longer than the LED. That still makes the system fully backward compatible AND totally user serviceable.
Parenthetically, I'm not saying that everyone prefers a system that is fully backward compatible and totally user serviceable. We could create a whole new industry of previously unnecessary lamp maintenance shops, to artifically improve employment opportunities.
Blog That A-Ha Moment Larry Desjardin 10 comments Have you ever had an a-ha moment? Sure, you have. The Merriam-Webster dictionary defines it as "a moment of sudden realization, inspiration, insight, recognition, or ...