Breaking News
Comments
Newest First | Oldest First | Threaded View
cgul
User Rank
Rookie
re: Implementing battery charger using Li-ion
cgul   9/27/2012 6:39:20 PM
NO RATINGS
Implementing battery charger using Li-ion. I have used Linear Technologies battery chargers for Li-Ion and Li-Poly. They work great. Using digital pots in place of fixed resistors for the charging voltage and charging current. These of course controlled with a micro-controller. life doesn't get any better than that. The micro allows for charging algorithms to suit different battery chemistry's and provides for status flexibility. It doesn't get any simpler than that. Piece of cake.

anne-francoise.pele
User Rank
CEO
re: Implementing battery charger using Li-ion
anne-francoise.pele   7/16/2012 3:25:01 PM
NO RATINGS
In Part One of this two-part article, Cypress describes different types of rechargeable batteries, their differences and how to select a battery technology for a specific application. The article is available here: http://www.eetimes.com/design/smart-energy-design/4375627/Battery--The-source-of-a-device---Part-1?Ecosystem=smart-energy-design

Hughston
User Rank
CEO
re: Implementing battery charger using Li-ion
Hughston   7/9/2012 4:09:09 PM
NO RATINGS
I don't think they mean to use the PSoC strictly for this function, but as a part of the overall PSoC system function. The battery health can be judged by a gas gage IC. They generate pulses proportional to the current versus time of the charge. Use it with a processor and you can make decisions about battery life.

Hughston
User Rank
CEO
re: Implementing battery charger using Li-ion
Hughston   7/9/2012 4:00:28 PM
NO RATINGS
Sometimes a regulator with a current limiting resistor on the input side is used as a cheap coin cell charger. The precharge time is very short, under a minute, on a Li-Ion battery. I think if the resistor was on the output side, it would be hard to top off the battery. You can use a simple 2 transistor circuit to up the current when the cell voltage goes up.

WKetel
User Rank
Rookie
re: Implementing battery charger using Li-ion
WKetel   7/4/2012 5:12:02 PM
NO RATINGS
Now a question about simplification of the process: would a current limited constant voltage charge work as well? It would not be as fast, it may take overnight to recharge completely, but it would certainly be simpler. Most importantly, would it damage the cells to start out with a current limited constant voltage charge? Or is it a situation that must have the higher voltage at the beginning?

MarkeSys
User Rank
Rookie
re: Implementing battery charger using Li-ion
MarkeSys   6/28/2012 7:11:34 PM
NO RATINGS
Another possibility for being able to use a single-ended ADC in this system would be to simply put a small-value resistor in series with the negative terminal of the battery pack, before its ground connection. This way the microcontroller system and the power supply can share the same ground. There is a small efficiency cost, but this can be mitigated by using a very small-value resistor, (for example, a 0.1 ohm resistor at 100mA would drop 10mV, at a power cost of only 1 mW).

Sanjib.A
User Rank
CEO
re: Implementing battery charger using Li-ion
Sanjib.A   6/26/2012 4:37:17 PM
NO RATINGS
Unless a sophisticated charging circuit is needed, using a PSoC would be an overkill. In general standard charging ICs will need a lot less design efforts. But some time, the user might need to know the health life of the battery, how many charging cycles took place etc. In that case this will be helpful.

GREAT-Terry
User Rank
CEO
re: Implementing battery charger using Li-ion
GREAT-Terry   6/26/2012 3:58:46 PM
NO RATINGS
Good article!



EE Life
Frankenstein's Fix, Teardowns, Sideshows, Design Contests, Reader Content & More
Max Maxfield

Aging Brass: Cow Poop vs. Horse Doo-Doo
Max Maxfield
40 comments
As you may recall, one of the things I want to do with the brass panels I'm using in my Inamorata Prognostication Engine is to make them look really old. Since everything is being mounted ...

EDN Staff

11 Summer Vacation Spots for Engineers
EDN Staff
11 comments
This collection of places from technology history, museums, and modern marvels is a roadmap for an engineering adventure that will take you around the world. Here are just a few spots ...

Glen Chenier

Engineers Solve Analog/Digital Problem, Invent Creative Expletives
Glen Chenier
11 comments
- An analog engineer and a digital engineer join forces, use their respective skills, and pull a few bunnies out of a hat to troubleshoot a system with which they are completely ...

Larry Desjardin

Engineers Should Study Finance: 5 Reasons Why
Larry Desjardin
45 comments
I'm a big proponent of engineers learning financial basics. Why? Because engineers are making decisions all the time, in multiple ways. Having a good financial understanding guides these ...

Flash Poll
Like Us on Facebook
EE Times on Twitter
EE Times Twitter Feed

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)