Breaking News
Comments
Newest First | Oldest First | Threaded View
<<   <   Page 4 / 5   >   >>
Bert22306
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
Bert22306   1/10/2013 11:58:35 PM
NO RATINGS
First of all, it's not clear that lack of noise from EVs had any impact on the fatality stats posted in the article, is it? But more to the point. Electric motors under load have their own wonderful growling-whining sound. My suggestions is, don't mess with it. If anything, just amplify the sound some, at low speeds, if pedestrian safety is a real concern. And it would be best to allow each manufacturer to tune the sound of their own products, same as they do with ICE exhaust systems.

krisi
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
krisi   1/10/2013 11:44:28 PM
NO RATINGS
well, there is always a possibility of running into a person crossing the street that doesn't hear the car coming

elizabethsimon
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
elizabethsimon   1/10/2013 10:19:04 PM
NO RATINGS
I think that the most practical in terms of being easy to distinguish would be some sort of pulsing tone where the pulse rate increases in frequency as car speed increases. Also important, I think, would be a smooth transition to where the sound turns off. I also agree that some sort of standardization is needed with perhaps some options as to the tone frequencies chosen

Willpower99
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
Willpower99   1/10/2013 9:42:48 PM
NO RATINGS
Why can't radar sensors on the front and rear of the car be a solution instead? Otherwise I vote for the sound of the WARP engines from Star Trek.

l_rasmus
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
l_rasmus   1/10/2013 8:51:44 PM
NO RATINGS
It is blind people who pushed for these minimum sound requirements. I am a blind engineer, and know that this problem has been under discussion for more than 10 years. In Montgomery County, Maryland, pedestrian safety campaigns recommend that pedestrians "make eye contact" with drivers. Good luck getting me to do that. Sound from an "idling" car is just as important as from one in motion. As much as possible, we need to be able to hear vehicles which may collide with us as we cross streets. I think manufacturers are going to be sensible about the sounds they select; a lot of groundwork has already been laid.

any1
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
any1   1/10/2013 8:40:07 PM
NO RATINGS
I agree Big Paul. Don't we have enough noise pollution already without adding more? This is a bad idea. Are "quiet" EVs currently on the road grandfathered out of this requirement?

GMF
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
GMF   1/10/2013 8:04:15 PM
NO RATINGS
An EV (or all vehicles) should make noise iff there's a possibility of running into something.

Brian Fuller2
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
Brian Fuller2   1/10/2013 7:41:57 PM
NO RATINGS
@Big Paul, personal responsibility? What? That's so old school! ; ) Thanks for commenting!

krisi
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
krisi   1/10/2013 6:19:10 PM
NO RATINGS
Perhaps we need some specific standards for this noise...otherwise everyone will play a different tune like in cellphone rings...specifying the dB levels in not sufficient...people need to know it is car coming!

JollyPaul
User Rank
Author
re: Silicon Valley Nation: What should your EV sound like?
JollyPaul   1/10/2013 5:54:09 PM
NO RATINGS
If we are going down this road, then the new regulations need to apply to all vehicles, regardless of how it is powered (gas,EV,pedal power). Personally I think it is just a knee jerk reaction to new technology. People need to be aware of their surroundings and take responsibility for themselves. If you are clueless enough to walk in front of a moving car because it is not loud enough, Darwin will see you to the exit door soon enough for a cause unrelated to EVs.

<<   <   Page 4 / 5   >   >>


Radio
LATEST ARCHIVED BROADCAST

What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.

Brought to you by:

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Most Recent Comments
Like Us on Facebook
Special Video Section
With design sizes expected to increase by 5X through 2020, ...
01:48
Linear Technology’s LT8330 and LT8331, two Low Quiescent ...
The quality and reliability of Mill-Max's two-piece ...
LED lighting is an important feature in today’s and future ...
05:27
The LT8602 has two high voltage buck regulators with an ...
05:18
Silego Technology’s highly versatile Mixed-signal GreenPAK ...
The quality and reliability of Mill-Max's two-piece ...
01:34
Why the multicopter? It has every thing in it. 58 of ...
Security is important in all parts of the IoT chain, ...
Infineon explains their philosophy and why the multicopter ...
The LTC4282 Hot SwapTM controller allows a board to be ...
This video highlights the Zynq® UltraScale+™ MPSoC, and sho...
Homeowners may soon be able to store the energy generated ...
The LTC®6363 is a low power, low noise, fully differential ...
See the Virtex® UltraScale+™ FPGA with 32.75G backplane ...
Vincent Ching, applications engineer at Avago Technologies, ...
The LT®6375 is a unity-gain difference amplifier which ...
The LTC®4015 is a complete synchronous buck controller/ ...
10:35
The LTC®2983 measures a wide variety of temperature sensors ...
The LTC®3886 is a dual PolyPhase DC/DC synchronous ...