Embedded Systems Conference
Breaking News
Comments
Newest First | Oldest First | Threaded View
SteveKo
User Rank
Author
re: Reducing power in AMD processor core with RTL clock gating analysis
SteveKo   3/1/2013 5:46:47 PM
NO RATINGS
Indeed, it's interesting that even our max power virus pattern only needs 15% of the flops clocked. There was a lot of designer work optimizing clock gating, but Calypto's SLEC methodology helped show what could be done too. Tools evolve and designers gain experience, leading to ever lower active flop counts.

SteveKo
User Rank
Author
re: Reducing power in AMD processor core with RTL clock gating analysis
SteveKo   3/1/2013 5:42:03 PM
NO RATINGS
:-) About 10 years ago we did some serious looking into a clockless X86 design for deep low power, but the toolsets for efficient timing closure weren't there. And providing sufficiently robust async timing for state machines eats into perceived benefits. I think clock trees and meshes with optimized gating strategies will be with us for a while.

SteveKo
User Rank
Author
re: Reducing power in AMD processor core with RTL clock gating analysis
SteveKo   3/1/2013 5:38:54 PM
NO RATINGS
GMN had a good reply for SAIF usage, we used the Calypto recommended flow for that technical decision. For PowerPro to PTPX, we were not using their newer version which estimates actual power, we were looking and clock gating efficiency. However, there was useful correlation there. As per table 2, we achieved about a 25% reduction in flop activity rate from one design to the next, and that correlated with about 25% lower dynamic power for typical applications. (As a short point of interest, we did check how much power tended to be used per active flop on one of our early runs. But block-to-block varied a fair bit. As one would expect, blocks with lots of combination logic like floating point had more gate fanout capacitance per flop than other blocks).

GMN
User Rank
Author
re: Reducing power in AMD processor core with RTL clock gating analysis
GMN   2/22/2013 8:54:08 PM
NO RATINGS
PowerPro does use VCD and FSDB for more accurate analysis. However, if you are primarily concerned about clock gating efficiency, and not looking for peak power analysis, then SAIF is faster and more efficient

old account Frank Eory
User Rank
Author
re: Reducing power in AMD processor core with RTL clock gating analysis
old account Frank Eory   2/13/2013 2:18:03 PM
NO RATINGS
I find it amazing that after all these years of using clock gating to reduce power, the tools & methodologies continue to improve to such a degree that these types of large power reductions are still possible.

daleste
User Rank
Author
re: Reducing power in AMD processor core with RTL clock gating analysis
daleste   2/12/2013 3:29:59 AM
NO RATINGS
Good work to improve the efficiency of the design. What ever happened to the clock-less logic that was supposed to make all of this not needed?

yjchen
User Rank
Author
re: Reducing power in AMD processor core with RTL clock gating analysis
yjchen   2/8/2013 7:21:26 AM
NO RATINGS
Hi Steve, As you mentioned, the correlation between silicon and PTPX are about +/-10%. From your experience, what's the correlation between PowerPro and PTPX? And Powerpro between silicon? Besides, in your flow, the input of Powerpro is saif. Why don't you use real waveform, like vcd or fsdb? Thanks. yjchen



Radio
LATEST ARCHIVED BROADCAST
As data rates begin to move beyond 25 Gbps channels, new problems arise. Getting to 50 Gbps channels might not be possible with the traditional NRZ (2-level) signaling. PAM4 lets data rates double with only a small increase in channel bandwidth by sending two bits per symbol. But, it brings new measurement and analysis problems. Signal integrity sage Ransom Stephens will explain how PAM4 differs from NRZ and what to expect in design, measurement, and signal analysis.

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Like Us on Facebook
Special Video Section
The LTC®6363 is a low power, low noise, fully differential ...
Vincent Ching, applications engineer at Avago Technologies, ...
The LT®6375 is a unity-gain difference amplifier which ...
The LTC®4015 is a complete synchronous buck controller/ ...
10:35
The LTC®2983 measures a wide variety of temperature sensors ...
The LTC®3886 is a dual PolyPhase DC/DC synchronous ...
The LTC®2348-18 is an 18-bit, low noise 8-channel ...
The LT®3042 is a high performance low dropout linear ...
Chwan-Jye Foo (C.J Foo), product marketing manager for ...
The LT®3752/LT3752-1 are current mode PWM controllers ...
LED lighting is an important feature in today’s and future ...
Active balancing of series connected battery stacks exists ...
After a four-year absence, Infineon returns to Mobile World ...
A laptop’s 65-watt adapter can be made 6 times smaller and ...
An industry network should have device and data security at ...
The LTC2975 is a four-channel PMBus Power System Manager ...
In this video, a new high speed CMOS output comparator ...
The LT8640 is a 42V, 5A synchronous step-down regulator ...
The LTC2000 high-speed DAC has low noise and excellent ...
How do you protect the load and ensure output continues to ...