Design Con 2015
Breaking News
Comments
Oldest First | Newest First | Threaded View
Page 1 / 2   >   >>
US Made
User Rank
Rookie
re: Intel, ARM on even footing in Net of Things, says IDC
US Made   5/30/2013 8:56:49 PM
NO RATINGS
if x86 only focus only server and high margin, it is going to be another IBM. Leaving $5-$10 chips on the table is the most dangerous things for x86. MIPS and PowerPC will not penetrate unless management drastically come up with some real value...

Duane Benson
User Rank
Blogger
re: Intel, ARM on even footing in Net of Things, says IDC
Duane Benson   5/31/2013 3:40:22 AM
NO RATINGS
It will be quite an interesting battle between x86 and ARM. I could certainly see Intel eventually getting down to the tablet and smart phone levels of power consumption and cost - or at least close - but I can't see them going below that. The cut off point between "microcontroller-based embedded systems and sensor nodes" and an IOT device will be up for a debate that will influence this market quite a bit. For example, if a device consists of a small 32-bit ARM and a WiFi module, with a total bill of material cost of $15.00, is it too small to be considered IOT. What if that device is connected to your garage door so you can check status and open and close it remotely? I'd call that an IOT device even though it would quite likely be possible with 8 or 16 bit MCUs.

GroovyGeek
User Rank
CEO
re: Intel, ARM on even footing in Net of Things, says IDC
GroovyGeek   5/31/2013 7:46:38 AM
NO RATINGS
Intel has a long history in embedded controllers. And there is no reason to think that extreme low power is needed for the IOT. Last time I checked my cable box, TV, receiver, fridge and toaster were plugged in all the time. In fact, I am having a hard time coming up with anything running on battery power in my house that needs to communicate other than phones, tablets, laptops.

licence
User Rank
Manager
re: Intel, ARM on even footing in Net of Things, says IDC
licence   5/31/2013 8:42:18 AM
NO RATINGS
" And there is no reason to think that extreme low power is needed for the IOT. " Except for the fact the world needs to reduce its energy use wherever it can.

jangoneo
User Rank
Rookie
re: Intel, ARM on even footing in Net of Things, says IDC
jangoneo   5/31/2013 10:53:27 AM
NO RATINGS
Use case for IoT is infinite so once cannot ignore battery operated device. For ex :Chips enabling IOT can go into remote controls, wireless mouse/keyboards and even in remotely operated toys.

rick merritt
User Rank
Author
re: Intel, ARM on even footing in Net of Things, says IDC
rick merritt   5/31/2013 5:16:35 PM
NO RATINGS
It's important to note here that IDC is talking about Intelligent Systems which it defines as Net connected, secure systems that can run an OS. This includes much of what is IoT but does not include the sub-32-bit devices and sensors others put in the IoT category. It does include whopping embedded comms infrastructure systems where Intel has a good leg up and ARM is beginning to find sockets.

Duane Benson
User Rank
Blogger
re: Intel, ARM on even footing in Net of Things, says IDC
Duane Benson   5/31/2013 5:30:25 PM
NO RATINGS
My point isn't that Intel will not be a success in the IOT or that IOT devices in general don't need a lot of power. There's a huge spectrum and I believe that x86 will take quite a large swath of that spectrum of IOT applications. The point I was attempting to make is that if we take 8 and 16 bit devices out of the IOT classification, we are cutting out a very large portion of the IOT. It's down in that level that I don't think x86 will play a part.

jackOfManyTrades
User Rank
Manager
re: Intel, ARM on even footing in Net of Things, says IDC
jackOfManyTrades   6/3/2013 7:13:42 AM
NO RATINGS
I still don't understand what these 11 billion things are that need to be connected together. Adding internet connectivity to my fridge or toaster would add cost to them for no obvious benefit. Adding a sensor to my garage door is all very well, but for it to be able to open and close itself would take several hundred dollars worth or mechanical and electrical engineering. The only things I can think of in my house that would obviously benefit from internet connectivity are my electricity and gas meters, but in order for that to happen, I'd need new meters fitting at a cost far greater than the IoT functionality. What are all these things that need to be connected together?

old account Frank Eory
User Rank
Rookie
re: Intel, ARM on even footing in Net of Things, says IDC
old account Frank Eory   6/4/2013 12:52:50 AM
NO RATINGS
How about your cars?

jackOfManyTrades
User Rank
Manager
re: Intel, ARM on even footing in Net of Things, says IDC
jackOfManyTrades   6/4/2013 7:15:27 AM
NO RATINGS
Interesting. Not a huge market, though. I don't know what the total wordlwide market for new cars is, but it is just over 2 million here in the UK (for a population of 63 million), so about 1 per 30 people. I guess if I've got one in each car, one in my garage door, it might just add up. Actually, one of my cars is already connected to the internet: it is leased and I can log onto the leasing company's website and see sorts of stuff, including where I've been. As can the leasing company, of course. I don't know what the physical layer is - I assume GSM/3G.

Page 1 / 2   >   >>


Flash Poll
Top Comments of the Week
Like Us on Facebook
EE Times on Twitter
EE Times Twitter Feed

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
EE Life
Frankenstein's Fix, Teardowns, Sideshows, Design Contests, Reader Content & More
Max Maxfield

Curiosity Killed the Cat (Just Call Me Mr. Curiosity)
Max Maxfield
16 comments
My wife, Gina The Gorgeous, loves animals. She has two stupid dogs and two stupid cats. How stupid are they? Well, allow me to show you this video of the dogs that I made a couple of years ...

Martin Rowe

No 2014 Punkin Chunkin, What Will You Do?
Martin Rowe
Post a comment
American Thanksgiving is next week, and while some people watch (American) football all day, the real competition on TV has become Punkin Chunkin. But there will be no Punkin Chunkin on TV ...

Rich Quinnell

Making the Grade in Industrial Design
Rich Quinnell
13 comments
As every developer knows, there are the paper specifications for a product design, and then there are the real requirements. The paper specs are dry, bland, and rigidly numeric, making ...

Martin Rowe

Book Review: Controlling Radiated Emissions by Design
Martin Rowe
1 Comment
Controlling Radiated Emissions by Design, Third Edition, by Michel Mardiguian. Contributions by Donald L. Sweeney and Roger Swanberg. List price: $89.99 (e-book), $119 (hardcover).