Breaking News
Comments
Newest First | Oldest First | Threaded View
Page 1 / 2   >   >>
kfield
User Rank
Author
BIrthday cake contraptions
kfield   9/25/2013 12:29:39 PM
NO RATINGS
I love this silly device. It reminds me of the time that we had a birthday celebration for my dad at the family gathering place. The cake we ordered was a circus theme and had a paper circus tent mounted on straws above the cake. The wait staff had lit the candles on the cake which was sitting on a sideboard near our table. Much to our horror, we noticed the entire circus tent go up in flames. !!

Frank Eory
User Rank
Author
re: What were they thinking: Overly complex design
Frank Eory   7/3/2013 4:30:27 PM
NO RATINGS
"And Claim 1 is also unduely restrictive." I was thinking the same thing! Despite the typical obfuscated dialect known as "Patent English," this claim is incredibly narrow. Even if this silly invention might have had some commercial value, this patent offers very little protection.

kwada951
User Rank
Author
re: What were they thinking: Overly complex design
kwada951   6/6/2013 6:08:42 PM
NO RATINGS
To tell you the truth ... I would have used a pressurized canister of ethyl ether as the 'blower'. In this case, one would get a very impressive, albeit dangerous flame discharge effect!

BrianBailey
User Rank
Author
re: What were they thinking: Overly complex design
BrianBailey   6/4/2013 9:10:46 PM
NO RATINGS
Yes, I thought that was a strange restriction but did not dig into whether there was a similar patent with a dog, or cat or...

dforce441
User Rank
Author
re: What were they thinking: Overly complex design
dforce441   6/4/2013 5:04:31 PM
NO RATINGS
And Claim 1 is also unduely restrictive; you could dodge the patent by making the device look like Wile E. Coyote or the Big Bad Wolf instead of with human features.

BrianBailey
User Rank
Author
re: What were they thinking: Overly complex design
BrianBailey   6/4/2013 4:49:23 PM
NO RATINGS
I think I agree with you on that, and besides it gives them the opportunity to charge more when they have to defend it because nobody else understands it.

Battar
User Rank
Author
re: What were they thinking: Overly complex design
Battar   6/4/2013 6:09:12 AM
NO RATINGS
"Claim 1 of this patent is further obfuscated by the patent lawyers into an almost unintelligible bunch of babble" That sentence is true of about 90% of all the patent applications I've read, and ususally it's a lot worse than this example. I've seen "ground engaging rotary propelling device" written instead of "wheel". I suspect that if a patent lawyer were asked to write a sentence in plain English, would would discover that this is a task he is incapable of achieving.

George Gonzalez
User Rank
Author
re: What were they thinking: Overly complex design
George Gonzalez   6/4/2013 1:41:15 AM
NO RATINGS
Sometimes it's hard to stop, our friends at the old HP sometimes had trouble putting on the brakes. I recall one horrendously expensive 3D graphics terminal from them, where they even designed a special screwdriver, that snapped into a special holder clip, just for tweaking the convergence adjustments.

Victim
User Rank
Author
re: What were they thinking: Overly complex design
Victim   6/3/2013 7:50:01 PM
NO RATINGS
An improvement would be to use compressed CO2 or even better an inert gas such as N2 to improve the extinguishing capabilities. Added party fun to use He for the effect upon the party attendees' vocal chords.

bcarso
User Rank
Author
re: What were they thinking: Overly complex design
bcarso   6/3/2013 5:28:46 PM
NO RATINGS
For a wonderful example of overdesign to no good end, see the John Addis contribution about oscilloscope vertical amplifiers in the Jim Williams compendium Analog Circuit Design, Art, Science, and Personalities (ISBN 0750691662). He describes a design review at Tektronix where some younger engineers presented a circuit of astonishing complexity, at that point only simulated. The IC was going to require 1200 transistors. One section of the circuit is reproduced. After a bit of consideration, some of the seasoned staff reduced that section to three transistors and a current source (pp. 120-122). And there was virtually no degradation in performance --- except for a 33% loss in current gain, in fact noise would be reduced, and linearity and bandwidth increased! John told me that he wasn't sure if the suggestions were actually followed.

Page 1 / 2   >   >>


Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Radio
LATEST ARCHIVED BROADCAST

What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.

Brought to you by:

Most Recent Comments
Like Us on Facebook
Special Video Section
Wireless Power enables applications where it is difficult ...
07:41
LEDs are being used in current luxury model automotive ...
With design sizes expected to increase by 5X through 2020, ...
01:48
Linear Technology’s LT8330 and LT8331, two Low Quiescent ...
The quality and reliability of Mill-Max's two-piece ...
LED lighting is an important feature in today’s and future ...
05:27
The LT8602 has two high voltage buck regulators with an ...
05:18
Silego Technology’s highly versatile Mixed-signal GreenPAK ...
The quality and reliability of Mill-Max's two-piece ...
01:34
Why the multicopter? It has every thing in it. 58 of ...
Security is important in all parts of the IoT chain, ...
Infineon explains their philosophy and why the multicopter ...
The LTC4282 Hot SwapTM controller allows a board to be ...
This video highlights the Zynq® UltraScale+™ MPSoC, and sho...
Homeowners may soon be able to store the energy generated ...
The LTC®6363 is a low power, low noise, fully differential ...
See the Virtex® UltraScale+™ FPGA with 32.75G backplane ...
Vincent Ching, applications engineer at Avago Technologies, ...
The LT®6375 is a unity-gain difference amplifier which ...
The LTC®4015 is a complete synchronous buck controller/ ...
10:35