I love this silly device. It reminds me of the time that we had a birthday celebration for my dad at the family gathering place. The cake we ordered was a circus theme and had a paper circus tent mounted on straws above the cake. The wait staff had lit the candles on the cake which was sitting on a sideboard near our table. Much to our horror, we noticed the entire circus tent go up in flames. !!
"And Claim 1 is also unduely restrictive." I was thinking the same thing! Despite the typical obfuscated dialect known as "Patent English," this claim is incredibly narrow. Even if this silly invention might have had some commercial value, this patent offers very little protection.
"Claim 1 of this patent is further obfuscated by the patent lawyers into an almost unintelligible bunch of babble"
That sentence is true of about 90% of all the patent applications I've read, and ususally it's a lot worse than this example. I've seen "ground engaging rotary propelling device" written instead of "wheel". I suspect that if a patent lawyer were asked to write a sentence in plain English, would would discover that this is a task he is incapable of achieving.
Sometimes it's hard to stop, our friends at the old HP sometimes had trouble putting on the brakes. I recall one horrendously expensive 3D graphics terminal from them, where they even designed a special screwdriver, that snapped into a special holder clip, just for tweaking the convergence adjustments.
An improvement would be to use compressed CO2 or even better an inert gas such as N2 to improve the extinguishing capabilities. Added party fun to use He for the effect upon the party attendees' vocal chords.
For a wonderful example of overdesign to no good end, see the John Addis contribution about oscilloscope vertical amplifiers in the Jim Williams compendium Analog Circuit Design, Art, Science, and Personalities (ISBN 0750691662). He describes a design review at Tektronix where some younger engineers presented a circuit of astonishing complexity, at that point only simulated. The IC was going to require 1200 transistors. One section of the circuit is reproduced. After a bit of consideration, some of the seasoned staff reduced that section to three transistors and a current source (pp. 120-122). And there was virtually no degradation in performance --- except for a 33% loss in current gain, in fact noise would be reduced, and linearity and bandwidth increased!
John told me that he wasn't sure if the suggestions were actually followed.
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.