Breaking News
Comments
Newest First | Oldest First | Threaded View
<<   <   Page 2 / 3   >   >>
jmumford913
User Rank
Author
Re: Put the barometer away...
jmumford913   7/12/2013 12:53:00 PM
NO RATINGS
It does involve the barometer, at least insofar as safely storing it and protecting the environment from a nasty mercury spill.

Obviously your sarcasm detector was miscalibrated, as I was commenting on the disastrous toxic exposure risks involved in some of the suggestions (dropping it off the building, launching it over the building, etc.) 

Consider it recalibrated (your sarcasm detector, not the barometer).

tom-ii
User Rank
Author
Correct use?
tom-ii   7/12/2013 12:28:56 PM
NO RATINGS
Has anyone mentioned the correct use?  Measure air pressure at bas of building, then air pressure at the top.  Find the difference and use that to compute the altitude...  Of course, you might need to take a trip to the beach to find the presseure at sea level, too...

Max The Magnificent
User Rank
Author
Re: Another Way!
Max The Magnificent   7/12/2013 10:28:13 AM
NO RATINGS
@Docdivakar: I would like to add another...

All Good suggestions. Another one I read was to set stand at the bottom of the building holding the barometer -- remotely detonate an explosion at the top of the buliding -- and measure the amount of time it takes the pressuse wave to register on the barometer :-)

Max The Magnificent
User Rank
Author
Re: 142 ways
Max The Magnificent   7/12/2013 10:25:13 AM
NO RATINGS
@n1ist: Climb the stairs and mark off the height in barometer-length units.

That would work -- this reminds me of the Smoot as a non-standard unit of length.

Max The Magnificent
User Rank
Author
Re: The laser or flashlight solution
Max The Magnificent   7/12/2013 10:22:35 AM
NO RATINGS
@Ron: Point the laser at the top of the building and measure the angle that the laser/flashlamp is tilted....

There are many ways to calculate the height of a building ... the point of this exercise is to use th ebarometer in one way or another.

Max The Magnificent
User Rank
Author
Re: Put the barometer away...
Max The Magnificent   7/12/2013 10:20:24 AM
NO RATINGS
@jhm001: ...then go down to the local building department and pull the blueprints for the building.

But that doesn't involve using the barometer, which is a key requirement for the exercise.

docdivakar
User Rank
Author
Another Way!
docdivakar   7/11/2013 9:40:25 PM
NO RATINGS
Max, I would like to add another: have the students measure the reading on ground floor, and then climb two more floors, take readings in each and get the delta in pressure between floors. Count the number of storeys in the building and use USGS data charts to get the exact height. There will be some minor inaccuracy in this since the pressure drop vs. elevation curve is not linear, quadratic.

MP Divakar

docdivakar
User Rank
Author
Re: Measuring a Building's Height With a Barometer
docdivakar   7/11/2013 9:20:03 PM
NO RATINGS
Max, you may want to lookup one of the Communications Society event I chaired:

http://comsocscv.org/,

Nov 2012: Technologies for Location Determination in Indoor and Urban Environments.

The speaker from NextNav (formerly @Trimble Navigation) does allude to atmospheric pressure measurement as one of the reliable ways (need 10Pa resolution). This can be accomplished by MEMS pressure sensors in a smart phone BUT it needs to be quite precise and must correlate to a reference system.

MP Divakar

n1ist
User Rank
Author
Re: 142 ways
n1ist   7/11/2013 8:32:17 PM
NO RATINGS
Climb the stairs and mark off the height in barometer-length units.

_hm
User Rank
Author
Will it work in Tibet?
_hm   7/11/2013 6:52:34 PM
NO RATINGS
Will this ideas work in Tibet? Do you need more processing of data or extra measurement?

 

<<   <   Page 2 / 3   >   >>


Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Like Us on Facebook
Special Video Section
5G LTE is on the way. These systems will require more ...
Protecting sensitive electronic circuitry from voltage ...
09:45
Watch as a web server authenticates or rejects a water ...
Protecting sensitive electronic circuitry from voltage ...
Watch as a web server authenticates or rejects a water ...
Protecting sensitive electronic circuitry from voltage ...
Power can be a gating factor in success or failure of ...
Get to market faster and connect your next product to the ...
00:44
See how microQSFP is setting a new standard for tomorrow’s ...
The LTC3649 step-down regulator combines key features of a ...
Once the base layer of a design has been taped out, making ...
In this short video we show an LED light demo to ...
The LTC2380-24 is a versatile 24-bit SAR ADC that combines ...
In this short video we show an LED light demo to ...
02:46
Wireless Power enables applications where it is difficult ...
07:41
LEDs are being used in current luxury model automotive ...
With design sizes expected to increase by 5X through 2020, ...
01:48
Linear Technology’s LT8330 and LT8331, two Low Quiescent ...
The quality and reliability of Mill-Max's two-piece ...