Breaking News
<<   <   Page 2 / 3   >   >>
User Rank
Rookie
Re: Put the barometer away...
7/12/2013 12:53:00 PM
NO RATINGS
It does involve the barometer, at least insofar as safely storing it and protecting the environment from a nasty mercury spill.

Obviously your sarcasm detector was miscalibrated, as I was commenting on the disastrous toxic exposure risks involved in some of the suggestions (dropping it off the building, launching it over the building, etc.)

Consider it recalibrated (your sarcasm detector, not the barometer).

User Rank
Blogger
Correct use?
7/12/2013 12:28:56 PM
NO RATINGS
Has anyone mentioned the correct use?  Measure air pressure at bas of building, then air pressure at the top.  Find the difference and use that to compute the altitude...  Of course, you might need to take a trip to the beach to find the presseure at sea level, too...

User Rank
Blogger
Re: Another Way!
7/12/2013 10:28:13 AM
NO RATINGS
@Docdivakar: I would like to add another...

All Good suggestions. Another one I read was to set stand at the bottom of the building holding the barometer -- remotely detonate an explosion at the top of the buliding -- and measure the amount of time it takes the pressuse wave to register on the barometer :-)

User Rank
Blogger
Re: 142 ways
7/12/2013 10:25:13 AM
NO RATINGS
@n1ist: Climb the stairs and mark off the height in barometer-length units.

That would work -- this reminds me of the Smoot as a non-standard unit of length.

User Rank
Blogger
Re: The laser or flashlight solution
7/12/2013 10:22:35 AM
NO RATINGS
@Ron: Point the laser at the top of the building and measure the angle that the laser/flashlamp is tilted....

There are many ways to calculate the height of a building ... the point of this exercise is to use th ebarometer in one way or another.

User Rank
Blogger
Re: Put the barometer away...
7/12/2013 10:20:24 AM
NO RATINGS
@jhm001: ...then go down to the local building department and pull the blueprints for the building.

But that doesn't involve using the barometer, which is a key requirement for the exercise.

User Rank
CEO
Another Way!
7/11/2013 9:40:25 PM
NO RATINGS
Max, I would like to add another: have the students measure the reading on ground floor, and then climb two more floors, take readings in each and get the delta in pressure between floors. Count the number of storeys in the building and use USGS data charts to get the exact height. There will be some minor inaccuracy in this since the pressure drop vs. elevation curve is not linear, quadratic.

MP Divakar

User Rank
CEO
Re: Measuring a Building's Height With a Barometer
7/11/2013 9:20:03 PM
NO RATINGS
Max, you may want to lookup one of the Communications Society event I chaired:

http://comsocscv.org/,

Nov 2012: Technologies for Location Determination in Indoor and Urban Environments.

The speaker from NextNav (formerly @Trimble Navigation) does allude to atmospheric pressure measurement as one of the reliable ways (need 10Pa resolution). This can be accomplished by MEMS pressure sensors in a smart phone BUT it needs to be quite precise and must correlate to a reference system.

MP Divakar

User Rank
Rookie
Re: 142 ways
7/11/2013 8:32:17 PM
NO RATINGS
Climb the stairs and mark off the height in barometer-length units.

User Rank
CEO
Will it work in Tibet?
7/11/2013 6:52:34 PM
NO RATINGS
Will this ideas work in Tibet? Do you need more processing of data or extra measurement?

<<   <   Page 2 / 3   >   >>

Flash Poll

#### Datasheets.com Parts Search

##### 185 million searchable parts (please enter a part number or hit search to begin)
Frankenstein's Fix, Teardowns, Sideshows, Design Contests, Reader Content & More
Betajet">

The Circle, a satirical, dystopian novel published in 2013 by San Francisco-based writer Dave Eggers, is about a large, very powerful technology company that combines aspects of Google, ...

I'm not sure if I read more than most folks or not, but I do I know that I spend quite a lot of time reading. I hate to be idle, so I always have a book or two somewhere about my person -- ...

latest comment TonyTib

No 2014 Punkin Chunkin, What Will You Do? 2 comments
American Thanksgiving is next week, and while some people watch (American) football all day, the real competition on TV has become Punkin Chunkin. But there will be no Punkin Chunkin on TV ...

latest comment MeasurementBlues

As every developer knows, there are the paper specifications for a product design, and then there are the real requirements. The paper specs are dry, bland, and rigidly numeric, making ...

latest comment MWagner_MA
Special Video Section
The LT8640 is a 42V, 5A synchronous step-down regulator ...
5:52
The LTC2000 high-speed DAC has low noise and excellent ...
5:14
How do you protect the load and ensure output continues to ...
6:54
General-purpose DACs have applications in instrumentation, ...
7:34
Linear Technology demonstrates its latest measurement ...
10:29
Demos from Maxim Integrated at Electronica 2014 show ...
4:17
Bosch CEO Stefan Finkbeiner shows off latest combo and ...
5:59
STMicroelectronics demoed this simple gesture control ...
2:15
Keysight shows you what signals lurk in real-time at 510MHz ...
4:17
TE Connectivity's clear-plastic, full-size model car shows ...
3:42
Why culture makes Linear Tech a winner.
6:08
Recently formed Architects of Modern Power consortium ...
6:39
Specially modified Corvette C7 Stingray responds to ex Indy ...
8:52
Avago’s ACPL-K30T is the first solid-state driver qualified ...
2:42
NXP launches its line of multi-gate, multifunction, ...
4:56
Doug Bailey, VP of marketing at Power Integrations, gives a ...
9:28
See how to ease software bring-up with DesignWare IP ...
5:19
DesignWare IP Prototyping Kits enable fast software ...
4:01
This video explores the LT3086, a new member of our LDO+ ...
7:03
In today’s modern electronic systems, the need for power ...
5:48