I messed around with primitive PWM amplifiers a little in the 80s, and always wanted to - but never got around to - replace the conventional HF bias + audio drive scheme in my home-made cassette deck with a straight square wave drive width-modulated with the audio.
In those days you had to roll your own, but these days there are some - already long in the tooth - PWM power amplifier configurations that can run at around 50kHz. Stick the audio signal into that and drive the resulting current into the head - should produce a myuch broader dip in the distortion curve and be less critical of bias level versus metal formulation. Simpler circuitry too - no separate bias power amp and record driver.
When (not if, Max!) this gets published in EET, I'd like to get hold of a table of the frequency response data, pre-equalization. I'm the first person to get excited about doing special filters, but this is a case where a digitally-implemented equalizer could probably do a super job. Implemented on the replay side, you could use a reel of calibration wire to give standardized excitation, and then everyone's wire recorder can be calibrated to have a super-flat frequency response! If that's what floats your boat, anyway.
@DrZuhoch: I still have one in my shop somewhere...I'll see if I can find it and send pictures.
Please do send the pictures to me at email@example.com and maybe we can do a follow-up column on this. I'd also love to see some pictures of a wire recorder being used as a form of computer memory as mentioned elsewhere in ths icomment thread.
I never throw anything away,and I still have one in my shop somewhere...I'll see if I can find it and send pictures.I don't remember the last thing recorded on it, it was used as an office stenographer.