Design Con 2015
Breaking News
Comments
Newest First | Oldest First | Threaded View
Page 1 / 4   >   >>
eetcowie
User Rank
Blogger
Re: Nickel Iron
eetcowie   5/12/2014 9:37:45 AM
NO RATINGS
thanks for the info.

psingh335
User Rank
Rookie
Re: Nickel Iron
psingh335   5/11/2014 7:04:45 PM
NO RATINGS
Thank you very much for considering the inclusion of Nickel Iron batteries in your no doubt daunting task of discussing batteries and other storage media.

My main considration for NiFe batteries is (emergency) backup for solar PV during the hurricane season in Florida and the Southern US. The sun is shining but the power line is broken.

A second consideration would be the initial cost of installation, compared to lead-acid, and never having to dispose of these batteries.

The US Solar PV dealers/suppliers do not want to discuss NiFe batteries. The utility companies just do not want solar grid-tie, especially with batteries.

The US manufactured NiFe are expensive.

Do not forget to mention ex-Tonight Show host Jay Leno, the most famous NiFe battery user.

As if you needed another source of energy storage:please mention super-caps that are becoming available an in use by some renewable power generators.

eetcowie
User Rank
Blogger
Re: Charging Batteries
eetcowie   5/9/2014 2:53:16 PM
NO RATINGS
Pulse charging, became popular after Nickel Cadmium came out, to measure the internal resistance. It did something like what you describe, but also had the advantage to help break loose (spoken loosely) materials from the electrodes (or in the case of NiCd to help prevent the formation of micro-fine shorts).

eetcowie
User Rank
Blogger
Re: Nickel Iron
eetcowie   5/9/2014 2:45:27 PM
NO RATINGS
Ahh, I will add it to the list.

Thanks!

psingh335
User Rank
Rookie
Re: Charging Batteries
psingh335   5/9/2014 2:20:44 PM
NO RATINGS
I have read of people who are re-using lead acid batteries which have been withdrawn from automotive service, and they use DC with an AC component, for charging.

psingh335
User Rank
Rookie
Nickel Iron
psingh335   5/9/2014 2:13:55 PM
NO RATINGS
It would be remiss to ignore NiFe, since the Chinese battery makers are in full production mode.

No liquids or semi liquids in transportation.

zeeglen
User Rank
Blogger
Re: Charging Batteries
zeeglen   2/3/2014 3:15:48 PM
NO RATINGS
@ Stargzer  Back in the mid-to-late 70s Popular Electronics had a simple circuit for a NiCd zapper.

I think it was Pop'tronics that also said a shorted NiCd could sometimes be burned open by momentarily placing it in parallel with a fully charged NiCd cell.  It did work a few times.


Stargzer
User Rank
CEO
Re: Charging Batteries
Stargzer   2/3/2014 12:56:28 PM
NO RATINGS
@eetcowie: "Also, Nickel Cadmium types were notorious for growing metal-fiber 'wires', that would partially short out a cell. There appeared a capacitor-based rejuvenator that would pulse a high-current into the cell to blow out the metal fibers and breathe new life."

Back in the mid-to-late 70s Popular Electronics had a simple circuit for a NiCd zapper.  It had a 24V transformer and a full-wave bridge that charged a capacitor, and it had a selector switch (charge or zap), a pushbutton to zap, and a meter to monitor the charge on the cap and on the battery.  A friend built one to try to resurrect some surplus NiCds he'd bought.  One let out a tremendous FLASH and a ZAP, and then started to take a charge.  The article said if it didn't start taking a charge after 2 or 3 zaps it never would.  He was able to recover most of the "dead" batteries.  Not much of a special waveform, but at the cost of used batteries, you didn't lose much by trying.  I doubt that would work for Li cells!

I also read that another failure mode with NiCds was that a weak cell caught in a string of good cells would be charged in reverse.

 

NielV
User Rank
Rookie
Re: Life of a battery
NielV   12/15/2013 2:23:09 PM
NO RATINGS
Keep in mind a Pb-based battery needs to be kept fully charged or it dies, so it is derated to allow for capacity loss over the expected life of a battery.  And in some countries you need to crank at very low temperature where you have only say 25% capacity available.  In temperate climates you can get away with a much smaller battery, especially when you consider you do not have to keep the battery fully charged.  It is commonly stated you need only half the capacity of a Pb-based battery.  Shipping of Li is an issue, however if each cell is less than 20Wh then it is not that hard.

eetcowie
User Rank
Blogger
Re: Life of a battery
eetcowie   12/11/2013 12:00:33 PM
NO RATINGS
The amount of lithium it would take to get a battery capacity similar to a car battery creates a little shipping trouble. However, you can find them at places like www.lithionicsbattery.com/rv.html.

Page 1 / 4   >   >>


Top Comments of the Week
Flash Poll
Like Us on Facebook

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
EE Life
Frankenstein's Fix, Teardowns, Sideshows, Design Contests, Reader Content & More
<b><a href=Betajet">

The Circle – The Future's Imperfect in the Present Tense
Betajet
Post a comment
The Circle, a satirical, dystopian novel published in 2013 by San Francisco-based writer Dave Eggers, is about a large, very powerful technology company that combines aspects of Google, ...

Max Maxfield

Recommended Reads From the Engineer's Bookshelf
Max Maxfield
2 comments
I'm not sure if I read more than most folks or not, but I do I know that I spend quite a lot of time reading. I hate to be idle, so I always have a book or two somewhere about my person -- ...

Martin Rowe

No 2014 Punkin Chunkin, What Will You Do?
Martin Rowe
2 comments
American Thanksgiving is next week, and while some people watch (American) football all day, the real competition on TV has become Punkin Chunkin. But there will be no Punkin Chunkin on TV ...

Rich Quinnell

Making the Grade in Industrial Design
Rich Quinnell
15 comments
As every developer knows, there are the paper specifications for a product design, and then there are the real requirements. The paper specs are dry, bland, and rigidly numeric, making ...

Special Video Section
The LT8640 is a 42V, 5A synchronous step-down regulator ...
The LTC2000 high-speed DAC has low noise and excellent ...
How do you protect the load and ensure output continues to ...
General-purpose DACs have applications in instrumentation, ...
Linear Technology demonstrates its latest measurement ...
10:29
Demos from Maxim Integrated at Electronica 2014 show ...
Bosch CEO Stefan Finkbeiner shows off latest combo and ...
STMicroelectronics demoed this simple gesture control ...
Keysight shows you what signals lurk in real-time at 510MHz ...
TE Connectivity's clear-plastic, full-size model car shows ...
Why culture makes Linear Tech a winner.
Recently formed Architects of Modern Power consortium ...
Specially modified Corvette C7 Stingray responds to ex Indy ...
Avago’s ACPL-K30T is the first solid-state driver qualified ...
NXP launches its line of multi-gate, multifunction, ...
Doug Bailey, VP of marketing at Power Integrations, gives a ...
See how to ease software bring-up with DesignWare IP ...
DesignWare IP Prototyping Kits enable fast software ...
This video explores the LT3086, a new member of our LDO+ ...
In today’s modern electronic systems, the need for power ...