Breaking News
Comments
Newest First | Oldest First | Threaded View
resistion
User Rank
Author
Re: Threshold switching and compliance
resistion   1/2/2014 7:53:42 PM
NO RATINGS
Well, the READ is close to the SET condition, due to proximity of Vth to Vread. Yet compliance wouldn't be applied during READ, so it would likely prove a fatal disturb.

resistion
User Rank
Author
Re: Sidewall film thickness
resistion   1/2/2014 7:41:57 PM
NO RATINGS
Yes, 40 nm TiO2 and 20 nm TaOx on the sidewall would push the overall half-pitch well over 130 nm. And these were done by PVD, not expected to succeed for the inevitably much higher aspect ratios.

Much thinner would be much better, but then it's likely these layers would be leaking undesirably.

Ron Neale
User Rank
Author
Re: Sidewall film thickness
Ron Neale   1/1/2014 12:10:29 PM
NO RATINGS

 

Resistion- If, by not practical, you mean that it is not possible to fabricate such a structure then you might be right. Although not included in my review above, I looked at the practicality of the problem of the cumulative thickness of layers building up on the side walls of the vertical structure. Although the devices in the paper are relatively large I did considered a device where the minimum feature size (F) was 20nm, still much larger than where next generation NV memory must go. I also assumed it would be possible to reduce the side wall layer thickness for the TiO,and TaOx to 10nm and I did not leave a centre space; that is I completely filled in the space between the two facing sidewalls of TaOx with tantalum. For a two cell structure this would give a single cell size of a little over 5/2F2, compared with the 4F2 for a simple 2D crossover matrix. The practicality of the repeatable deposition of 10nm films (about 70 atoms thick) on the vertical side walls and then in-filling a deep, high aspect ratio, 10nm wide space between two TaOx surfaces with tantalum is non trivial but in a gedankenexperiment anything is possible.

Ron Neale
User Rank
Author
Re: Threshold switching and compliance
Ron Neale   1/1/2014 7:29:05 AM
NO RATINGS
Resistion: The authors of the 3D Vertical TaOx/TiO2 RRAM paper in their list of claims for their devices stated "forming free, self rectifying, self compliance and highly stable BRS."

I did not investigate the details of the compliance claims any further because I assumed that for some time ahead the array would be monolithically integrated with silicon and the memory array driver/decoder circuits would take care of providing compliance.

resistion
User Rank
Author
Sidewall film thickness
resistion   12/31/2013 7:49:28 PM
NO RATINGS
If you're going to use sidewall films, they have to be thin, less than 10 nm, otherwise it's not practical.

resistion
User Rank
Author
Threshold switching
resistion   12/31/2013 7:38:58 PM
NO RATINGS
The problem with the threshold switching is that it needs another device to provide current compliance.



Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Radio
LATEST ARCHIVED BROADCAST

What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.

Brought to you by:

Like Us on Facebook
Special Video Section
The LTC2380-24 is a versatile 24-bit SAR ADC that combines ...
In this short video we show an LED light demo to ...
02:46
Wireless Power enables applications where it is difficult ...
07:41
LEDs are being used in current luxury model automotive ...
With design sizes expected to increase by 5X through 2020, ...
01:48
Linear Technology’s LT8330 and LT8331, two Low Quiescent ...
The quality and reliability of Mill-Max's two-piece ...
LED lighting is an important feature in today’s and future ...
05:27
The LT8602 has two high voltage buck regulators with an ...
05:18
Silego Technology’s highly versatile Mixed-signal GreenPAK ...
The quality and reliability of Mill-Max's two-piece ...
01:34
Why the multicopter? It has every thing in it. 58 of ...
Security is important in all parts of the IoT chain, ...
Infineon explains their philosophy and why the multicopter ...
The LTC4282 Hot SwapTM controller allows a board to be ...
This video highlights the Zynq® UltraScale+™ MPSoC, and sho...
Homeowners may soon be able to store the energy generated ...
The LTC®6363 is a low power, low noise, fully differential ...
See the Virtex® UltraScale+™ FPGA with 32.75G backplane ...
Vincent Ching, applications engineer at Avago Technologies, ...