Breaking News
Comments
Newest First | Oldest First | Threaded View
resistion
User Rank
Author
vacuum-dependent bonding?
resistion   1/28/2014 2:59:28 PM
If the bonded wafer needs to go into a vacuum for further processing, it could slip off, right?

chipmonk0
User Rank
Author
Progress in 3-d chip stacking has been held back by..
chipmonk0   1/27/2014 11:56:51 AM
too many Govt. funded European Labs getting involved and putting out misleading white noise branded as scientific research. They are neither result oriented nor sufficiently grounded in Physics or comprehensive methodologies to develop whole new technologies for commercial application. Rather than comprehend the total challenge they indulge only in piecewise optimization - the result : endless "Technical" Conferences that evade the core technical challenges but keep harping on cost & supply chain issues instead!

Only belatedly have these European "Researchers" recognized the folly of the process flow ( derived from "Powerpoint Engr." w/o the benefit of Physics, data or even Engr. common sense ! ) they have been blindly following and so now this article talks about the issues related to temporary bonding / debonding steps in 3-d stacking of wafers / dice !

The whole wafer bonding / debonding step that these European Labs & Suppliers are still going on about has been eliminated by US companies who are now making 3-d stacked chip products commercially with a radically different material set & process flow.

 

 

zewde yeraswork
User Rank
Author
balance
zewde yeraswork   1/27/2014 11:43:31 AM
NO RATINGS
It may be necessary to strike a balance between high costs on the one hand and other limitations on the other hand.



Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Radio
NEXT UPCOMING BROADCAST

What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.
Like Us on Facebook
Special Video Section
LED lighting is an important feature in today’s and future ...
05:27
The LT8602 has two high voltage buck regulators with an ...
05:18
The quality and reliability of Mill-Max's two-piece ...
01:34
Why the multicopter? It has every thing in it. 58 of ...
Security is important in all parts of the IoT chain, ...
Infineon explains their philosophy and why the multicopter ...
The LTC4282 Hot SwapTM controller allows a board to be ...
This video highlights the Zynq® UltraScale+™ MPSoC, and sho...
Homeowners may soon be able to store the energy generated ...
The LTC®6363 is a low power, low noise, fully differential ...
See the Virtex® UltraScale+™ FPGA with 32.75G backplane ...
Vincent Ching, applications engineer at Avago Technologies, ...
The LT®6375 is a unity-gain difference amplifier which ...
The LTC®4015 is a complete synchronous buck controller/ ...
10:35
The LTC®2983 measures a wide variety of temperature sensors ...
The LTC®3886 is a dual PolyPhase DC/DC synchronous ...
The LTC®2348-18 is an 18-bit, low noise 8-channel ...
The LT®3042 is a high performance low dropout linear ...