@Max: the hot-off-the-press news is that, almost as soon as I'd posted this blog, I heard that the rumor in the street is that Yageo has agreed to continue supplying marked SMD resistors to Digi-Key and other Distributors.
I just got confirmation of that from Yageo. My two questions are:
1. Since they didn't change the part number, how can I be assured that I will not receive any of the millions of unmarked ones they just produced?
2. Will ALL of their new resistors be marked now, or is it just by request? Aside from looking at each reel, how will the distributors be able to tell the difference?
I sent an inquiry to Yageo a few minutes ago. I'll post the response here.
I was thinking about ceramic 0603s where I standardize tempco and voltage. Below 1nF they should all be 50V NPO and between 1nF and 100nF they should all be 50V X7R. Above 100nF things start getting complicated. And yes in higher voltage circuits we have some higher voltage parts. I guess I see your point.
@Wnderer: The very least they could do is color code them within a factor of ten.
That would really help, but for 1206 and larger they could just as easily write the value.
On second thought, perhaps they could write the value and then use a color code for the voltage or dielectric type.
Now that we're talking about this, perhaps the reason they don't mark them is that for a resistor you can tell the approximate wattage just from looking at it, and you can guesstimate the maximum allowable voltage too, but for capacitors, it would be good to know the value, the voltage, and the tempco at least.
@Rick: Like I said, I would GLADLY pay extra for that.
Actually, I think you said "I would gladly pay double to get capacitors with markings on them." ... So, if I bought a reel of capacitors for $x and market them up, you'd pay me $2x ... maybe I should go into business doing this LOL
Hi Rick -- the hot-off-the-press news is that, almost as soon as I'd posted this blog, I heard that the rumor in the street is that Yageo has agreed to continue supplying marked SMD resistors to Digi-Key and other Distributors.
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.