Can you please let me know if transformerless opearation is possible with current mode line driver as shown in the figure (which pulls current from the transformer center tap), and with 50 ohm termination resistors (with center point coupled to gnd with cap) completely implemented inside the phy device. i.e the resistors are not accessible on the pins of the component.
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.