Design Con 2015
Breaking News
Comments
Newest First | Oldest First | Threaded View
<<   <   Page 3 / 3
Bill_Jaffa
User Rank
Blogger
Re: Stories versus wires
Bill_Jaffa   4/7/2014 1:19:21 PM
NO RATINGS
Sometimes it is both more than OK  and actually a smart thing to use an "uncool" technique; otherwise, you risk the solution being more complicated than the problem!

MeasurementBlues
User Rank
Blogger
Re: Stories versus wires
MeasurementBlues   4/7/2014 1:10:02 PM
NO RATINGS
I wrote about the whole thing in some deatil a while ago.

See Multimeter traces home wiring.

Using a multimeter is so uncool. Today, You've need to do the same thing using a phone app as a TDR.

Bill_Jaffa
User Rank
Blogger
Re: Stories versus wires
Bill_Jaffa   4/7/2014 12:50:08 PM
NO RATINGS
Sounds like you should go Kickstarter and get some up-front funding to make it into a small prject, then get some distributor of building-wiring products to carry it!

MeasurementBlues
User Rank
Blogger
Stories versus wires
MeasurementBlues   4/7/2014 12:45:02 PM
NO RATINGS
"The one-wire continuity problem was one I had faced in the past, when I was helping a friend fixing up a very old two-story house."

Two story, one wire, but I ahve three stories. Does that mean I have two wires? Actually, I have 12 Ethernet lines with eight wires each. To locate and document the connections, I used a DMM after making a test cable that shorted the two middle wires together. Then I just had to run around with the sorting cable to each Ethernet jack and listen for hte beep in the wiring closer where all Ehternet lines come out of the wall.

Bill_Jaffa
User Rank
Blogger
Re: Audible continuity checkers
Bill_Jaffa   4/7/2014 12:26:34 PM
NO RATINGS
Good point--as usual, it's a good idea to stop and think first, decide if you need a basic short vs open test, or something a little more sophisticated.

MeasurementBlues
User Rank
Blogger
Audible continuity checkers
MeasurementBlues   4/7/2014 12:14:53 PM
NO RATINGS
Those DMMs with audible continuity testers will sound when the resistance measured is below some threshhold, but not always that close to zero ohms. In same cases, you get the beep but the resistance is still too high for things to work.

<<   <   Page 3 / 3


Flash Poll
Top Comments of the Week
Like Us on Facebook
EE Times on Twitter
EE Times Twitter Feed

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
EE Life
Frankenstein's Fix, Teardowns, Sideshows, Design Contests, Reader Content & More
Max Maxfield

DIY Practical Joke Project Idea
Max Maxfield
12 comments
I just received a rather interesting email from a member of the EETimes community who prefers to remain anonymous. This message was as follows:

Jolt Judges and Andrew Binstock

Jolt Awards: The Best Books
Jolt Judges and Andrew Binstock
1 Comment
As we do every year, Dr. Dobb's recognizes the best books of the last 12 months via the Jolt Awards -- our cycle of product awards given out every two months in each of six categories. No ...

Engineering Investigations

Air Conditioner Falls From Window, Still Works
Engineering Investigations
2 comments
It's autumn in New England. The leaves are turning to red, orange, and gold, my roses are in their second bloom, and it's time to remove the air conditioner from the window. On September ...

David Blaza

The Other Tesla
David Blaza
5 comments
I find myself going to Kickstarter and Indiegogo on a regular basis these days because they have become real innovation marketplaces. As far as I'm concerned, this is where a lot of cool ...