It was the best of 'scopes, It was the worst of 'scopes, it was the age of condensers. it was the age of capacitors, It was the epoch of resistors, it was the epoch of wires, It was the season of LEDs, It was the season of CCDs. It was the spring of coils, It was the winter of diodes, We had everything before internet, we had nothing after the singularity, We were all going straight to engineering Heaven, we were all going direct the other way -- in short the manual was so far like the present manual that some of its noisiest authorities insisted on its being received for Apple or Samsung in the superlative degree of comparison only.
tell me more - Translations - some can be figured out, some are humourous, some use words that don't exist, some are totally confusing.
1.1 Accidence of the front panel and user interface
easy-to-use front panel to convenience users to operate them, the panel contains knobs and buttons.
Using this knob can ... Set the Video Linage,
Connect the probe to the oscilloscope and connect the ground terminal to ground before you take any measurements. (well, duhhh!)
Note：If you connect a voltage source to a ground terminal, you may damage the oscilloscope or the circuit under test. To avoid this, do not connect a voltage source to any ground terminals. (again, duhhh!)
When you operate the self Calibration, you should cut all the probes and lead.
...the on-screen lathy rectangle shapes represent the front panel keys.
Turn the "Universal" knob when holdoff time have been to max or min value, now the system will clew this information.
The signal must be mediacy horizontal
When you operate, the screen would display the white (Color LCD) and black (single LCD) repose.
USB Flash Drive Plug In! : This information will appear when you invert the USB Flash Drive to the USB Host port.
Check the attenuation quotiety whether match the probe attenuation proportion or not.
Attempt to change the " coupling" into "HF Reject" or "LF Reject" display, so that the High/low frequency noise disturb the trigger should be filtrated
When you see the signal at the slow speed（from 10μs/div start）, you can capture high-frequency burr which are narrow to 10ns.
It Usually only have dry insulative pollution It must be prospective that it is instant electric because of icing once in a way.
The guys at Oscium (who make an amazing iPad-based oscilloscope that I use all the time) just sent me this link to the donkey from the Shrek movie shouting "Pick me! Pick me!" http://youtu.be/Dj3GH5myc3M
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.