Breaking News
Oldest First | Newest First | Threaded View
User Rank
Grids not as important anymore
Wnderer   5/22/2014 11:23:52 AM
I think radial grids have been around for a long time. I recall a board done on the old Calay CAD that ran on the PDP11 that had to fit in the nose cone of an airplane that I think had parts laid out on a radial grid. The problem with radial grids was meshing them with the square grid.

In the old days grids were important. There was no automated spacing checking. The spacing was calculated by the grids you used. The boards would be laid out 8, 8 and 8 or 8 mil traces and 8 mil spaces on an 8 mil grid. By placing the 8 mil traces on the next grid that didn't contact the trace next to it, you would get the 8 mil spacing. If you laid out part of the board radially some of the pads wouldn't fall on the 8 mil grid and maintaining the spacing requirements would be difficult.

Today I switch grids while laying out a board all the time. The software maintains the spacing and checks for errors.

Max The Magnificent
User Rank
Re: Grids not as important anymore
Max The Magnificent   5/22/2014 11:32:04 AM
@Wnderer: I think radial grids have been around for a long time...

That may well be -- and it seems as though they are in a lot of today's tools -- the surporising thing is how few of us know this capability exists.

User Rank
Re: Grids not as important anymore
xjordanx_#1   5/22/2014 7:28:30 PM
I remember first using radial grids in AutoCAD, but not for PCB design of course.


Then the problem was you had to switch between them - you couldn't mix, match and prioritize, and nor could you set the origin of multiple different grids or offset their rotation.


I suppose it's just one of those things that most ofthe time you wouldn't need it, but then that one time you do, if it's not there, you're basically up the creek without a paddle.


It was sure a big time saver for my stroboscope. Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)

What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.

Brought to you by:

Most Recent Comments
rick merritt
Max The Magnificent
Like Us on Facebook
Special Video Section
Power can be a gating factor in success or failure of ...
Get to market faster and connect your next product to the ...
See how microQSFP is setting a new standard for tomorrow’s ...
The LTC3649 step-down regulator combines key features of a ...
Once the base layer of a design has been taped out, making ...
In this short video we show an LED light demo to ...
The LTC2380-24 is a versatile 24-bit SAR ADC that combines ...
In this short video we show an LED light demo to ...
Wireless Power enables applications where it is difficult ...
LEDs are being used in current luxury model automotive ...
With design sizes expected to increase by 5X through 2020, ...
Linear Technology’s LT8330 and LT8331, two Low Quiescent ...
The quality and reliability of Mill-Max's two-piece ...
LED lighting is an important feature in today’s and future ...
The LT8602 has two high voltage buck regulators with an ...
Silego Technology’s highly versatile Mixed-signal GreenPAK ...
The quality and reliability of Mill-Max's two-piece ...
Why the multicopter? It has every thing in it. 58 of ...
Security is important in all parts of the IoT chain, ...
Infineon explains their philosophy and why the multicopter ...