I love my old Magnavox. Tubes have such a nice sound when playing an old Chuck Mangioni album. However, I must admit that I rigged it so that I can feed in Air Play from my Mac via my wireless network. The kids really get a kick out of playing Jazz from their iPhone on an old Tube amp. My daugher in music school is hooked on the sound.
I still have two tube radios. I've got a Hallicrafters S-38, 1940's (I think) vintage short wave radio. I haven't turned it on in a few years, but it worked just fine the last time I did.
I've also got a 1929 Atwater Kent TRF (tuned radio frequency) radio. Unfortunately, I don't have the cabinet. Just the radio. I haven't turned it on since about 1984, but it did work then. The sound wasn't so great after my rather lousy job of re-coning the speaker. I'm a little afraid to turn it on now, because of the old capacitors.
@Max: You would be wise to replace all the paper and electrolytic capacitors BEFORE applying power. You don't want to fry a hard-to-obtain vacuum tube. And there is a lot more that goes wrong with tubes than just their heaters/filaments.
That Grundig radio probably has a power transformer so the heaters will be in parallel, unlike the series connected heaters in the "All American 5".
There is a Yahoo group called "Fun with tubes" that have a lot of good information on restoring antique radios and designing guitar amplifiers.
When I was a little kid my parents had a Grundig radio that looked very similar.
First off, diagnosing vacuum tube [sorry "valve"!] falures is not too hard. It is the filament that gives out. If it doesn't glow and get hot, it's dead. Unfortunately, some designed wire all the filaments in series, so, when one dies, they all appear dead. So you ned to pull each one and check its filament. A bit like Christmas tree lights ..
Is that an ASR33 Teletype outside your office? If so, why??
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.