The purpose of the wrist band is to provide ahigh-resistance (leakage path) from you to whatever you're working on. So if your circuit is floating and you're connected to the low side of its power supply, you should be OK. If the power supplye is indeed connected to the ground lead of the AC mains, then that's better.
Some years ago, I was installing a new hard drive in my desktop PC. When I powered it up, the power sypply fan came on, but nothing else. I had zapped the motherboard and needed a new one. Since that day, I always wear an ESD wrist strap.
Having just returned from the EMC Symposium, I'm reminded that there is, as Bruce Archambeault will tell you, there's no such thing as ground except perhaps in this case, for safety.
Too often, we use the term "ground" when we really mean "return" as in current returning to its source. Ground is a reference voltage. Current shuld not flow through a ground wire at all. When it does, you have samety and EMC problems.
I did something similar when I had to set up on a table that was inconvineiently far from a wall socket. Since I needed a multi lead outlet strip with a long cord to power the equipment, I attached the cable from the antistatic mat to a ground on the outlet strip (which was located on the far side of the table). I then attached the lead from the wrist strap to a banana jack at the grounding point on the antistatic mat (which was on the edge near the front of the table). This minimized the stretching of the wrist strap cord and the whole thing could be moved fairly easily by unplugging the outlet strip from the wall and rolling it (and the cables) inside the antistatic mat.
@mhrackin: ...and i noticed that they have a TWO-WIRE UNGROUNDED (and unpolarized) AC plug.
1,000 curses-- you are of course 100% correct -- in fact Ivan came bouncing into my office about 30 minutes ago saying the same thing -- and as soon as he said it I remembered that my notepad also has a 2-pin power plug.
Max, the use of the USB and the use of the power strip are NOT mutually exclusive! It would make sense to use the power strip regardless, just to reduce the excess bending over (although perhaps the exercise is beneficial!). I'd still vote for plugging directly into the U-ground hole rather than depending on the combined continuity of the series chain of alligator clip to USB shield wire to PC USB connector through PC internals to DC ground of power jack to power supply, thence (maybe) to the U-ground of the power cord into the AC outlet! Far too many points of failure there (and of the most unreliable system element: interconnections!).
I don't know what flavor notepad you are using, but I have a number of Lenovo Thinkpad power supplies on my desk right now, and i noticed that they have a TWO-WIRE UNGROUNDED (and unpolarized) AC plug. I also have some ancient Dell ones with 3-wire cords. Obviously, there's no point in ohming out the Thinkpad ones as there is NO input ground. The Dells do have the ground continuous (1.2 ohms) to the shell of the DC power plug. However, these are REALLY old (from XP PCs) so your results may differ.
Drones are, in essence, flying autonomous vehicles. Pros and cons surrounding drones today might well foreshadow the debate over the development of self-driving cars. In the context of a strongly regulated aviation industry, "self-flying" drones pose a fresh challenge. How safe is it to fly drones in different environments? Should drones be required for visual line of sight – as are piloted airplanes? Join EE Times' Junko Yoshida as she moderates a panel of drone experts.