Embedded Systems Conference
Breaking News
Comments
Newest First | Oldest First | Threaded View
pawanapt
User Rank
Author
Re: Thanks!
pawanapt   8/22/2014 5:44:43 AM
NO RATINGS
Hi Robert . This is Pawan Bothra - APT Electronics ( P ) Ltd India . We are ODM for led drivers for Philips . In one of our 300W projects we are using interleaved PFC followed by interleaved PWM flyback converter . BOTH the stages use the same IC UCC28061 . I had used this with the anticipation that the BULK ELCO ( 450V ) at the o/p of the interleaving PFC stage will further be reduced by the virtue of interleaving in the next stage .

We have made prototypes and I am looking for some theroritical studies or will do some theoritical calculations where the  ripple current of the said bulk elco can be calculated with variation of the duty cycles of both stages .

Further I am even thinking of using SG3524/3525 for the interleaving stages.

 

TI- delhi team is aware of the project.

 

Regards,

 

Pawan Bothra.

pawanapt@hotmail.com.

 

 

green_is_now
User Rank
Author
duty cycle vs interleaving #
green_is_now   8/21/2014 3:05:47 PM
NO RATINGS
Robert,

further down the refinement onion...

When the duty cycle is exactly 50% and the ramp slope going up and down is exactly the same the ripple cancels and aproaches zero!

minus the edge spikes, dead time, edge jitter...but these are an order of magnitude smaller problems than bulk ripple.

But power supplies don't operate at this point, but can be tailored for a specific sweet spot where a supply typically operates.

If your system can tolerate more ripple outside the sweet spot your done. If not, then something else needs to be done.

And ripple specs are worst case across the load range.

Perhaps a layered article that builds on this one can go into the benifits of N phase interleaving and how it helps and the deminishing returns of adding more than 3 or 4 interleaved sections provide.

Also some insight into how big or small a problem of variable ripple% is over load can be would be useful. Comparing 2 phase with 3 phase over load would be a great example to raise understanding.

 

Also how dynamic voltage scalling can buy some headroom for ripple issues, especially at low load to high load transition points where the extra voltage headroom has limited impact, as both ripple and ramp response determine brownout and overvoltage failure points, with and without dynamic proactive voltage scalling also has a lot of value toward cleaner and more efficient SMPS design.

rich.pell
User Rank
Author
Re: Thanks!
rich.pell   8/20/2014 10:17:42 AM
NO RATINGS
Yes, a big thank you to Robert Kollman for six years (!) of Power Tips. For a listing (with links) of all 74 Power Tips, check out the Power Tips Index (Word .doc file).

Ryszard.Milewicz
User Rank
Author
Thanks!
Ryszard.Milewicz   8/19/2014 5:37:03 PM
NO RATINGS
Hi Robert,

thank you very much for all tips, ideas and suggestions, which can be used in everyday design work. All the best!



Radio
LATEST ARCHIVED BROADCAST
As data rates begin to move beyond 25 Gbps channels, new problems arise. Getting to 50 Gbps channels might not be possible with the traditional NRZ (2-level) signaling. PAM4 lets data rates double with only a small increase in channel bandwidth by sending two bits per symbol. But, it brings new measurement and analysis problems. Signal integrity sage Ransom Stephens will explain how PAM4 differs from NRZ and what to expect in design, measurement, and signal analysis.

Datasheets.com Parts Search

185 million searchable parts
(please enter a part number or hit search to begin)
Like Us on Facebook
Special Video Section
The LTC®6363 is a low power, low noise, fully differential ...
Vincent Ching, applications engineer at Avago Technologies, ...
The LT®6375 is a unity-gain difference amplifier which ...
The LTC®4015 is a complete synchronous buck controller/ ...
10:35
The LTC®2983 measures a wide variety of temperature sensors ...
The LTC®3886 is a dual PolyPhase DC/DC synchronous ...
The LTC®2348-18 is an 18-bit, low noise 8-channel ...
The LT®3042 is a high performance low dropout linear ...
Chwan-Jye Foo (C.J Foo), product marketing manager for ...
The LT®3752/LT3752-1 are current mode PWM controllers ...
LED lighting is an important feature in today’s and future ...
Active balancing of series connected battery stacks exists ...
After a four-year absence, Infineon returns to Mobile World ...
A laptop’s 65-watt adapter can be made 6 times smaller and ...
An industry network should have device and data security at ...
The LTC2975 is a four-channel PMBus Power System Manager ...
In this video, a new high speed CMOS output comparator ...
The LT8640 is a 42V, 5A synchronous step-down regulator ...
The LTC2000 high-speed DAC has low noise and excellent ...
How do you protect the load and ensure output continues to ...