I think the IT guys have disabled links in comments due to spaming -- can you post the contact details for the hotel -- also what dates are the Hamfest? I was thinking that we could all drive up on Wed -- go on a museum tour (to be organized by Antedeluvian) on Thur -- and got to the Hamfest on Fri and Sat -- then drive back on Sun
Talked to my friend Joe; he and his wife are going, and haven't missed ONE in at least 20 years! They did warn that you need to make hotel reservations NOW as this is one of the major annual events at the convention center! I made mine today, and there were few rooms left (at this hotel), and rates of course are high. Anywhere in the airport area works well; if you wait, you may have to stay in Cleveland!
BTW, my wife is THRILLED at the idea! Looking forward to the USAF museum etc.
32768's are a peeve of mine, and their history is illuminating.
The value was chosen (1970s?) for its obvious ease in converting to integral seconds, but it is difficult to get that value in the type of 'cut' that gets the best thermal stability ('A-T'), so a less-stable (and very small) one was used ('Tuning-Fork'). And hey! the thermal drift didn't even matter! if you have a reasonable-quality watch, look at the back. It's metal, isn't it? The front has an air-gap, and is therefore thermally-insulated. What is the temperature of the workings while the watch is securely strapped to your wrist? Pretty close to 37°, eh?
Now take that tried-and-true ol' reliable crystal and put it in a desk clock, and thermal drift might surprize you.
@DrFPGA If you pre-heated it to the right temp could you get it to switch every second?
Probably not. We're talking about something thermal that probably needs a large piece of hysteresis between the heating turn on and cooling to turn off. If you kept it heated up it would never turn off. You would need to use a higher voltage which might damage the tube or you could control an external heater to increase the rate of heating that shuts off when the relay goes on.
Reading Max's article again, it probably doesn't fit into his Vetinari Clock concept. It just the way my brain segways. I would use the relay to trigger the up/down counter on a 64 tap digital pot like the AD5113 and use a comparator to reset the pot when it hits 60. The comparator would trigger another digital pot that resets at 24 or 12. An all analog solution with no programming.
What are the engineering and design challenges in creating successful IoT devices? These devices are usually small, resource-constrained electronics designed to sense, collect, send, and/or interpret data. Some of the devices need to be smart enough to act upon data in real time, 24/7. Are the design challenges the same as with embedded systems, but with a little developer- and IT-skills added in? What do engineers need to know? Rick Merritt talks with two experts about the tools and best options for designing IoT devices in 2016. Specifically the guests will discuss sensors, security, and lessons from IoT deployments.