Please confirm the information below before signing in. Already have an account? Sign In.
Please wait you will be redirected shortly.
We've sent an email with instructions to create a new password. Your existing password has not been changed.
Sorry, we could not verify that email address. Enter your email below, and we'll send you another email.
Check your email for a link to verify your email address.
Thank you for verifiying your email address.
Your password has been successfully updated.
We didn't recognize that password reset code. Enter your email below, and we'll send you another email.
We've sent you an email with instructions to create a new password. Your existing password has not been changed.
can you explain slide 13 again.
quite similar to what Eric teaches.
Thank you Alfed and Martin.
Thank you Alfred!
sorry, my typo: replace "non-resonant" with non-50 ohms"".
Thanks Al, I'am begining to understand.
So if I measure the null-to-null spacing in the S11 plot from a non-resonant transmission line and then calculate the delay using your formula from yesterday: delta f in GHz) = 1/(2*Td) is Td also the group delay?
ukdave, thanks. That's often done on wafers as well, for failure analysis.
Good Afternoon, 9AM in the Morning here
Thank you Al
Joe, here's the lonk to yesterday's slides
The Cal Structures are on the same board PANEL but not part of your finished board.
Joe I'll get the link for you.
Travel glitches kept me form the class yesterday. Is the slide show and audio archived?
No. I wouldn't go this year.
On EMI/SI/PI panel and will be in the Simbeor Booth
Anyone going to DesignCon next week?
Remember to post questions here
Note freq is in 10's of GHz
What would the group delay average be?
so boards usually cal structures on them? What if there is no real estate?
Would you please define group delay?
Remember to post questions here.
jj is audio on now?
I'm going to need a refresher on Eigenvalues!
Audio is good
no audio, this webcast sucks!
Good evening from Valladolid, Spain in the West Europe
which slide is he on?
hi frm MN/St. Paul
Hi from GA
audio is up!!
Audio is live
Mishawaka is half way between Chicago and Detroit.
If you aim at Notre Dame you will miss Mishawaka by two miles.
Where is Mishawaka?
hello from Mishawaka
Greetings from Scottsdale, AZ
Colleen, what will yu do when Winter comes?
Good Morning Only 7 degrees this morning in Boston!
Everyone, remember to downlaod your sildes from Today's Slide Deck
Hello Rodney. It's time for me get this set up. Day 4.
G Morning All
Rock n Roll!
Test Tool Finds Ethernet Wiring Errors
Martin Rowe Post a comment
When my house was renovated several years ago, I had the electrician install network outlets in numerous places, then run the LAN cables to a wiring closet. But he didn't document the ends ...
Local Electronics Store Supplies Engineers and Hobbyists
Martin Rowe 5 comments
Rochester, N.Y. — Tucked away in this western New York city known for its optics is Goldcrest Electronics, a local store that's supplied businesses and individuals with electronic ...
How to Transform a Technology University (Book Review)
Martin Rowe 1 Comment
The Presiding Genius of the Place by Alison Chisolm. WPI, Worcester, Mass., 234 pp., 2016.
Engineers love to discuss, and often criticize, engineering education. They often claim ...
Aloha from EEWeb
Max Maxfield Post a comment
Just a few minutes ago as I pen these words, I posted this blog about this month's Cartoon Punchline Competition over on EEWeb.com.